User`s manual

FOX 500 Tx/Rx • Quick Start Guide
Quick Start Guide — FOX 500 Tx/Rx
QS-1
Install, connect, and operate the FOX 500 Tx/Rx as follows:
Step 1
Turn all of the equipment off or disconnect it from the power source.
If desired, mount the FOX 500 units in a rack or furniture, or place
them on desktops.
Step 2
Connect a VGA to UXGA source to the
transmitter: either to the RGB Input
15-pin HD connector or to the RGB Input
BNC connectors. See the drawing at right
to wire the BNC connectors.
Step 3
If desired, connect a local monitor to the
transmitter's Buffered Loop-Through
15-pin HD connector.
Step 4
Connect a balanced or unbalanced, stereo
or mono audio input to the transmitter:
either to the Audio Inputs 3.5 mm mini jack
or to the Audio Inputs 5-pole captive screw
connector. See the drawing at right to wire
the captive screw connector.
Step 5
If you want the FOX 500 to pass serial
signals, such as for serial control of a
projector, connect the master device to the transmitter and
the slave device to the receiver via three poles of the RS-232
Over Fiber captive screw connector on both units.
N
For RS-232 responses (from the receiver to the transmitter),
you must install fiber cable Optical 2. See Step 8.
Step 6
For serial control of the transmitter and receiver, connect
a host device to either unit via three poles of the Remote
RS-232/Alarm captive screw connector or to either unit's
front panel Configuration
connector.
RGBHV
H/HV V
RGBS
RGsB,
RsGsBs
H/HV V
H/HV V
R G B
R G B
R G B
RS-232
OVER FIBER
Tx Rx NA
Controlling
Device
Receive (Rx)
Transmit (Tx)
Ground ( )
Receive (Rx)
Transmit (Tx)
Ground ( )
Bidirectional
REMOTE
RS-232
ALARM
Tx Rx 1 2
Unbalanced Stereo Input
Balanced Stereo Input
L R L R
Ring
Sleeve (s)
Tip
Sleeve
Tip
Sleeve
Tip
Tip
Ring