User`s manual

FOX 500 Tx/Rx • Remote Control
Remote Control, cont’d
4-8
FOX 500 Tx/Rx • Remote Control
4-9
Command ASCII Command
(host to unit)
Response (unit to host)
Additional description
Video mute
Mute output 1B
Blk1
]
Blank the video output.
Unmute output 0B
Blk0
]
Output video.
Show video mute status B
X!]
Video ouput mute status is
X!
(0 = unmuted, 1 = muted).
Output sync format
Set output sync format
6*
X@
# Syn
X@]
Set the sync format. 0 = RGBHV, 1 = RGBS, 2 = RGsB.
Show output sync format 6#
X@]
Output sync polarity
Set output to sync negative 7*1#
Pol1
]
Receiver output sync (H and V for RGBHV, S for RGBS, or s for RGsB) is always negative.
Set output sync to follow the input
7*0#
Pol0
]
Output sync follows the video sync input to the transmitter.
Show the sync polarity 7#
X#]
Horizontal shift
Set a horizontal position
X$
H Hph
X$]
Set horizontal centering to
X$
.
Increment position. +H
Hph
X$]
Shift the image one pixel to the right.
Decrement position -H
Hph
X$]
Shift the image one pixel to the left.
Show position H
X$]
Command/response table for SIS commands
Command ASCII Command
(host to unit)
Response (unit to host)
Additional description
Vertical shift
Set a vertical position
X$
/ Vph
X$]
Set vertical centering to
X$
.
Increment position +/
Vph
X$]
Shift the image up one line.
Decrement position -/
Vph
X$]
Shift the image down one line.
Show position /
X$]
Horizontal start
N
When the controlling PC is connected to the receiver, the FOX 500 can perform this command only if the fiber 2 cable is connected. The unit
returns the E14 error if fiber 2 is not connected.
Set a start position
X%
) Hst
X%]
Set the horizontal location of the first active pixel in the active window.
Example:
128*)
Hst128
]
Set pixel 128 as the first active pixel.
Increment start position +)
Hst
X%]
Shift the horizontal start position one pixel to the right.
Decrement start position -)
Hst
X%]
Shift the horizontal start position one pixel to the left.
Show start position )
X%]
Pixel phase
N
When the controlling PC is connected to the receiver, the FOX 500 can perform this command only if the fiber 2 cable is connected. The unit
returns the E14 error if the fiber 2 cable is not connected.
Set a pixel phase value
X^
U Phs
X^]
Set the pixel phase value to
X^
.
Example:
10U
Phs10
]
Set the pixel phase value to 10.
Increment pixel phase +U
Phs
X^]
Increase pixel phase value by 1..
Decrement pixel phase -U
Phs
X^]
Decrease pixel phase value by 1.
Show pixel phase U
X^]
Command/response table for SIS commands (continued)