User Guide User guide

EDID101H • Installation 3
Installation and
Configuration
This section describes the installation, and configuration of the EDID101H, including:
Installation Overview
Front Panel Features
Rear Panel Features and Cabling
EDID Minder
EDID101H Configuration
Installation Overview
POWER
12V
0.3A MAX
EDID
STORE
AB
AB
C
OUTPUTINPUT
EDID HPD
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
ON
123
1
2 3 4 5 6
9
7
8
Figure 2. EDID101H Rear Panel
1. Mount the EDID101H (see Mounting the EDID101H on page15). Do not connect
power to the source, the display, or the EDID101H at this time.
TIP: If access to the EDID101H is restricted after mounting or installation,
configure the EDID101H prior to the installation.
3. Configure the EDID101H (see EDID101H Configuration on page11).
4. Connect an HDMI cable from the source to the Input (
b
).
5. Connect an HDMI cable from the Output (
c
) to the video display or distribution system
input.
6. Connect power and turn on the video display or distribution system.
7. Apply power to the EDID101H (
a
). The power LED lights green.
8. Turn on the video source.
The video source reads the EDID from the EDID101H.