Operating instructions

Programmer’s Guide, cont’d
Digital XPoint Matrix Switchers • Programmer’s Guide4-4
Command/Response Table for SIS commands
Symbol definitions
= Carriage return/line feed
= Carriage return (no line feed)
• = Space
X
1
= Input number 01 – 04 (Digital XPoint 44 SDI);
01 – 08 (Digital XPoint 88 SDI)
X
2
= Output number 01 – 04 (Digital XPoint 44 SDI);
01 – 08 (Digital XPoint 88 SDI)
X
3
= Input number (for tie) 0 – maximum number of inputs (0=disconnected)
Input and output numbers in commands may be entered as either 1-, 2-, or 3-digit numbers. All input
and output numbers are specified as 1-digit numbers in the response.
X
4
= Preset number 00 – 16 (0 = current configuration)
X
5
= Preset number 01 – 16
X
6
= On/off 1 = on;
0 = off
X
7
= Sync 1 = sync detected (signal present);
0 = no sync
X
8
= Controller software version number to second decimal place
X
9
= Total number of inputs
X10
= Total number of outputs
Command/response table for SIS commands
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Create ties
Tie input
X
3
to output
X
2
, all
X
3
*
X
2
! Out
X
2
•In
X
3
•All Video and audio tie. (DXP does
not support audio.)
Example: 1*3! Out3 •In1•All Tie input 1 all to output 3.
Tie input
X
3
to output
X
2
, video
X
3
*
X
2
% Out
X
2
•In
X
3
•Vid
Example: 7*5% Out5•In7•Vid Tie input 7 video to output 5.
Quick multiple tie
Esc
+Q
X
3
*
X
2
!…
X
3
*
X
2
! Qik
Example:
Esc
+Q3*4!3*5!3*6! Qik Tie input 3 to outputs 4, 5, and 6.
Tie input to all outputs
X
3
*! In
X
3
•All
Example: 5*! In05•All Tie input 5 to all outputs.
• The ! video tie command and the % all tie command can be used interchangeably on the
Digital XPoint models.
• Commands can be made back-to-back with no spaces. Example: 1*1!02*02!003*003!...
• The quick multiple tie and tie input to all outputs commands activate all switches
simultaneously.
Global presets
Save current configuration as preset
X
5
, Spr
X
5
Command character is a comma.
Example: 9, Spr09 Save current ties as preset 9.
Recall a preset
X
5
. Rpr
X
5
Command character is a period.
Example:5. Rpr05 Recall preset 5, which becomes
the current configuration.