User’s Guide DVI-RGB 100 Direct Digital Video to RGB Video Converter 68-610-01 Rev.
Installation Overview 7 100-240 Projector V SOG ON/OFF SPARE ED ER UGH FF BU RO TH OPLO /60 50 Hz SE NIT LE OR CT SELECTOR G B H V S OUTPUT Output connectors — Connect an RGB display to these female BNC connectors. For RGBS video — Connect to four BNC connectors as shown at right. Ensure that the SOG On/Off switch ( 6 ) is turned off. OR T INPU X MA R G B H V S R G B H V S R G B H V S For RGsB video — Connect to three BNC connectors as shown at right.
Installation Many monitors will not support all of the resolutions and refresh rates shown. If you get no display, try a different rate. 6 SOG (Sync on Green) On/Off switch— Set this switch to the On (up) position to enable SOG for RGsB video. Install a blank panel (included in the rack kit) or another 1U half-rack unit on the unused side of the rack. c. Connect the input, loop-through and output cables. See Rear Panel Connections and Controls. 3.
Indicators and Specifications 10 Peak(ing) control — The Peaking control affects the sharpness of the picture on the RGB output. Increased peaking can compensate for detail (mid- and high-frequency) loss from low bandwidth system components or capacitance in long cables. The minimum setting (at the counterclockwise limit) provides no peaking. The maximum setting (at the clockwise limit) provides 100% peaking. Adjust this control while viewing the displayed image to obtain the optimum picture sharpness.
Minimum/maximum levels ...... Impedance .................................... Return loss .................................... DC offset ....................................... 0.7V to 1.4V p-p (continuously adjustable) 75 ohms -35dB @ 5 MHz ±5mV maximum with input at 0 offset Sync Output type .................................. Output level .................................. Output impedance ....................... Polarity ..........................................
