User Manual

Control communications pass-through — The DVI 201xi Tx passes through RS-232 (two
way) or IR (one way) control signals, via the connected receiver, to a remote display.
Compact design — The transmitter is 1U high, a half rack wide and 3 inches deep, for easy
rack mounting near the source device.
Remote powering of receiver — Pin 5 of twisted pair cable 2 carries a 12 VDC signal that
allows the receiver to be powered from a single power supply connected to the transmitter.
1
2
12V
0.4A MAX
POWER
DVI-D INPUT
LOCAL OUTPUT
OUTPUTS
DO NOT CONNECT
OUTPUTS TO LAN
SN XXXXXXXX E XXXXX
00/00
DVI DL TX
STORE
EDID
Tx Rx
CONTROL
PASS THRU
DVI 201xi Tx
ON
1 2 3
ON
OFF
DEFAULT EDID
EDID MINDER
REMOTE DDC
DVI 201 Rx SERIES
DVI-D OUTPUT
CONTROL
PASS-THRU
Tx Rx
1
31
42
3
1
4
2
31
42
2
3
100
LINK
ACT
COM
IR
INPUT
RELAY
TX RX
R
IPL 250
®
ON
OFF
DISPLAY
MUTE
SCREEN
UP
SCREEN
DOWN
VCR
DVD
DOC
CAM
LAPTOP
PC
PC w/ DVI
Output
Local Monitor
DVI Cable
RS-232
Extron
DVI 201xi Tx
DVI Transmitter
Extron
DVI 201 Rx
DVI Receiver
Flat Panel Display
with DVI Input
RS-232
TCP/IP
TouchLink
™
Control
System
Extron
DTP26
Cable
Figure 1. Typical Application for the DVI 201xi Tx
DVI 201xi Tx • Introduction 2