User Manual
Extron USA - West
Headquarters
+800.633.9876
Inside USA/Canada
Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA/Canada
Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
© 2010 Extron Electronics. All rights reserved. www.extron.com
Installation Checklist
Install the DVI 201xi Tx as follows:
Step 1 — Configure the EDID:
Decide which display device will be used for the EDID information.
Configure the DDC switches (see DDC Switches on page 6 and Configuring EDID on
page 10)
If necessary, use the EDID Minder to read and store information from a display (see
Configuring EDID on page 10).
Step 2 — Connect the transmitter to a receiver:
Prepare twisted pair cables (see Terminating shielded cable on page 7).
Select a receiver that is compatible with the DVI 201xi Tx (see Twisted Pair Cable
Connections on page 9).
Connect it to the transmitter (see Twisted Pair Cable Connections on page 9).
Step 3 — Connect the source device and display devices:
Connect the source device to the transmitter (see DVI-D input on page 5). Do not power
on the source device at this time.
Connect the display device to the receiver (see the user guide for the receiver). If required,
connect a local monitor to the transmitter (see Local monitor output on page 5).
Step 4 — Connect any pass-through control devices (optional):
If required, connect any RS-232 or IR control devices (see Control Signal Pass-through
on page 6).
Step 5 — Apply power to the system:
Connect the power supply to either the transmitter or the receiver (see Power Input on
page 6 or the user guide for the receiver).
Power on the display device.
Power on and boot up the source device.