User Guide

DVI 110 • Installation 5

Signal

Pin Signal

Signal

1 TMDS data 2– 9 TMDS data 1– 17 TMDS data 0–

2 TMDS data 2+ 10 TMDS data 1+ 18 TMDS data 0+

3 TMDS data 2 11 TMDS data 1 19 TMDS data 0

shield shield shield

4 Spare 12 Spare 20 Spare

5 Spare 13 Spare 21 Spare

6 DDC clock 14 +5 V power 22 TMDS clock

shield

7 DDC data 15 Ground (+5 V) 23 TMDS clock+

8 CEC control 16 Hot plug 24 TMDS clock–

detect

Female Connector

Male Connector

Figure 5. DVI Connector Pin Assignments

c DVI-D input connector — Plug the cable from the source device into this single

link format female DVI connector. The table above shows the DVI pin conguration.

NOTE: Although this is actually a DVI-I connector, its analog pins are not enabled.

Only DVI-D signals are accepted.

d Power connector — Plug the external 12 V power supply (provided with the unit)

into this 2-pole captive screw connector. The ﬁgure below shows how to wire the

connector.

Power Supply

Output Cord

Captive Screw

Connector

SECTION A–A

Ridges

Smooth

Tie Wrap

3/16” (5 mm) Max.

Figure 6. Wiring the Power Connector

WARNING: Keep the two power cord wires separate while the power supply is

plugged in. Remove power before continuing.