User's Manual Owner's manual

Software-based Conﬁ guration and Control, cont’d

DVCM 50 • Software-based Conﬁ guration and Control

5-12

PRELIMINARY

5. If you want to assign another command to the same button, select the next

Cmd radio button, then repeat steps 3 and 4.

For each button, you can perform this procedure up to four times, until the

button’s four memory blocks are all assigned.

You must program the next command in order. You cannot, for example,

program memory block #1 (Cmd 1 radio button) then skip to block #3 or #4.

You can mix driver functions from different devices on the same button. For

example, you can program the Play button (in DVD mode) with one command

to start a Panasonic DVD player, and another command to start a Sony DVD

player.

6. When ﬁ nished programming commands to the button, click Close to close the

Driver Selection window.

Removing commands from a button

You can remove either one command from a button, or all the button’s commands

at once.

1. Select the button from which you want to remove commands. The button

becomes gray.

2. If you want to remove only one command from the button, select the Cmd

radio button for the memory block containing the command to be removed.

If you want to remove all the commands, you do not need to select a Cmd

radio button.

3. Under Remove IR/232 Codes in the Actions ﬁ eld, click one of the following

buttons:

• One Command — Removes the command from the selected memory

block only.

If you want to remove only one command at a time, you must remove

the commands in descending order; e.g., remove command 4 before

removing commands 3, 2, and 1.

• All Commands in Button — Removes all the commands from all the

memory blocks on the button.