User's Manual Owner's manual

Special Application, cont’d
DVCM 50 • Special Application
4-4
PRELIMINARY
DVCM 50 • Special Applications
4-4
PRELIMINARY
When the MLC 104 is connected to the DVCM 50, you can select between the VCR
and the DVD player by two methods:
Pressing an input button on the MLC 104
Pressing the DVD or VCR button on the DVCM 50.
You do not need to press both an MLC 104 button and a DVCM button to
select the VCR or DVD player.
Setting up buttons for DVD and VCR selection
On the MLC 104, you must specify one pair of input buttons that will be used to
select the VCR or the DVD player. You can select either buttons 1 and 2, or buttons
3 and 4 (you cannot use both pairs to select the DVD/VCR). Buttons 1 and 3 select
DVD mode, and buttons 2 and 4 select VCR mode. Pressing these buttons activates
the DVCM 50’s DVD or VCR buttons, which select the input device.
The DVD and VCR buttons on the DVCM 50 do not need to be specifi ed or programmed
to select the DVD or VCR. These buttons are preset to switch the system to DVD and
VCR mode when pressed, and their settings cannot be changed.
To select the DVD/VCR pair of input buttons, set confi guration DIP switch #4 on
the DVCM 50 rear panel as follows:
Place switch #4 in the Off (down) position to use button 1 to select the DVD
and button 2 to select the VCR.
Place switch #4 in the On (up) position to use button 3 to select the DVD and
button 4 to select the VCR.
1
ON
234
CONFIG
PROJECTOR
VOLUME
1
2
3
4
ON
OFF
Extron
MLC 104 IP AAP
DVD & VCR CONTROL
PLAY NEXT/FWD PAUSE STOP
TUNER
Tx
PREV/REW
ENTER
TITLE MENU
TV/VCR
DVD VCR
CONFIG
DVCM 50
DVCM 50 switch #4 is set
to Off (down) position,
selecting buttons 1 and 2.
DVD
VCR
DVD and VCR mapped to input buttons 1 and 2 on the MLC 104
•
•
•
•