User Guide Manual

DTP DVI 230 D Transmitter and Receiver • Installation and Operation 9
b DC power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector or the power input connector on the receiver (see Power
Supply Wiring on page 11 to wire the connector).
Receiver Front Panel
Figure 8 shows the front panel of the DTP DVI 230 D receiver.
OUTPUTS
DVI-D
AUDIO
Tx Rx GTxRx
RS-232 IR
OVER DTP
1
2
3
Figure 8. DTP DVI 230 D Receiver Front Panel Connectors
a DVI output connector — Connect a DVI display for the transmitted direct digital
image.
b Audio output connector — Connect a stereo audio device to this 3.5 mm mini stereo
jack to receive the unbalanced audio output (see figure 5 on page 7 to wire the audio
connector).
c RS-232 and IR (Control) pass-through connector — Connect a serial
communications port to this 3.5 mm, 5-pole captive screw connector for bidirectional
RS-232 communication and IR communication (see RS-232 and IR Connector
Wiring on page 12 to wire the connector).