User Guide Manual

DTP DVI 230 D Transmitter and Receiver • Introduction 6
Final Installation
After testing and making any adjustments, do the following:
1. At the power outlet, unplug the power supply.
NOTE: One power supply can power both the transmitter and the receiver (see
Power Supply Wiring on page 11 and Ground Loops on page 14).
2. Mount the transmitter or receiver into the wall box or mud ring, and attach the supplied
Decora faceplate to the unit, as shown in figure 2 on page 4.
3. At the power outlet, reconnect the power supply. This powers up both units.
Transmitter Connections
The DTP DVI 230 D transmitter is in an enclosure that can be mounted in UL-listed standard
wall boxes with Decora-style face plates.
Transmitter Front Panel
Figure 4 shows the front panel of the DTP DVI 230 D transmitter.
INPUTS
LOCAL OUT
DVI-D
AUDIO
REMOTE
DDC
ROUTE
LOCAL
Tx Rx GTxRx
RS-232 IR
ON
12
1
3
5
2
4
Figure 4. DTP DVI 230 D Transmitter Front Panel Connectors
a DVI input connector — Connect a DVI cable between this port and the DVI output
port of the digital video source.
b Local Out connector — Connect a DVI cable between this port and the DVI input of a
local monitor.
NOTE: In a system where the local output is not used, ensure that you power up
the end display before the video source. Route the DDC to the remote end (see
e on the next page).