User Guide Manual

DTP DVI 230 D Transmitter and Receiver • Introduction 4

To install a new wall box, perform steps 1 through 9. If a suitable wall box is already

installed, perform steps 6 through 9 on the next page. UL listed wall boxes are

recommended.

1. If a wall box is not available to use for a template, see Decora Template Dimensions

on page 15 to create a template. If installing directly into furniture, cut out the center

portion of your template.

2. Place the wall box (or your template) against the installation surface, and mark the

opening guidelines.

3. Cut out the material from the marked area.

4. Insert the wall box into the opening. The rear connectors on the box or wall plate should

fit easily into the opening. Enlarge or smooth the edges of the opening if needed.

5. Secure the wall box with nails or screws, leaving the front edge flush with the outer wall

or furniture surface (see figure 2).

NOTES:

• If attaching the wall box to wood, use four #8 or #10 screws or 10-penny

nails. A minimum of 0.5 inch (1.3 cm) of screw thread must penetrate the

wood.

• If attaching the wall box to metal studs or furniture, use four #8 or #10

self-tapping sheet metal screws or machine bolts with matching nuts.

Signal Output

Cable

Clamp

Decora Faceplate

Extron

DTP DVI 230 D

Screws or

Nails

Wall opening is

ﬂush with edge of box.

Wall Stud

LOCAL OUT

Tx Rx G Tx Rx

RS-232

INPUTS

DVI-D