User guide

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Matrix Software 64
Starting the program
1. To run the Matrix Switchers Control Program, click Start > Programs > Extron
Electronics > Matrix Switchers > MATRIX Switcher + Control Pgm.
The Comm Port Selection dialog box (see figure 34) opens.
Figure 34. Comm Port Selection Dialog box
2. Choose either the comm port that is connected to the serial port of the switcher, USB,
IP [LAN], or Emulate.
• If you selected a comm port, check the baud rate displayed in
the Baud Rate field. If you need to change the baud rate, click
Baud and double-click the desired baud rate.
• Click OK. The Extron Matrix Switchers Control Program window
(see figure 36 and figure 37 on page 66) opens, displaying the
current configuration of the attached matrix. Proceed to Using the program on the
next page.
• If you selected USB, select the DMS matrix switcher in the
drop-down window and click OK. Proceed to Using the program on
the next page/
• If you selected IP [LAN], click OK and proceed to step 3.
• If you selected Emulate, click OK and see Using Emulation Mode on page 82.