Setup guide

Front Panel
DMS 1600
TMDS DIGITAL MATRIX SWITCHER
POWER SUPPLY
PRIMARY
REDUNDANT
CONTROL
ENTER PRESET
VIEW
ESC
CONFIG
9 10
Figure 6. Front Panel Features
i
Configuration port — If desired, connect a control system or
computer to the front panel Configuration port, a mini USB B
port
.
j
Primary and Redundant Power Supply LEDs —
NOTE: The meaning of these indicators is identical to the
LEDs on the power supplies (item
g
).
Green — Indicates that the associated power supply is operating
within normal tolerances.
Red —
Indicates that the associated power supply is operating
outside the normal tolerances or has failed. See "Removing and
Installing a Fan" to replace the power supply.
Front Panel Operations
This section describes simple DMS matrix switcher operation from the
front panel. Topics that are covered include:
• Creating a Tie
• Viewing Ties (and Muting Outputs)
• Saving or Recalling a Preset
• Locking Out the Front Panel (Executive Mode)
Creating a Tie
1. Press and release the Esc button to clear any input button, output
button, or control button indicators that may be lit.
2. Press and release the desired input button.
5
The button lights to indicate the selection.
3. Press and release the desired output buttons.
3 4
ENTER
8
The output buttons blink to indicate the potential ties.
The Enter button blinks to indicate
the need to confirm the change.
4. Press and release the Enter button. All button indicators turn off.
See figure 2 in the "Installation" section. The input numbers
supported by the I/O board in locations 5 through 8 are as follows:
A = 5, B = 6, C = 7, D = 8.)
Viewing Ties (and Muting Outputs)
1. Press the View button. Output buttons light for outputs that have
no ties established.
NOTE: If an output button blinks, that output is muted. To
toggle mute on and off, press and hold the output
button for 2 seconds.
2. Press an input button. The buttons for all tied outputs light.
3. Press an output button. The buttons for the tied input and all tied
outputs light.
4. Press the View button again to exit View mode. All input and
output buttons return to an unlit state.
DMS 1600 and DMS 3600 • Front Panel Operations 98 DMS 1600 and DMS 3600 • Installation