Setup guide

Installation
This section describes installation of the DMS matrix switchers,
including connections and features. Topics that are covered include:
• Rear Panel
• Front Panel
Rear Panel
A Note on I/O Boards
See figure 2. Each I/O board is identified by the input and output
connector numbers supported by the board position. The input and
output numbers on the boards are identified as locations A through
D.
ANAHEIM, CA
100-240V 50/60Hz 1.2A MAX.
PRIMARY POWER SUPPLY
1 - 4
5 - 8
9 - 12
A
B
C
D
E
F
OUT
IN
OUT
IN
OUT
IN
OUT
IN
OUT
IN
OUT
A
B
C
D
E
F
OUT
IN
OUT
IN
OUT
IN
OUT
IN
OUT
IN
OUT
IN
13 - 16
DVI-D INPUTS
A B
DVI-D INPUTS DV
C D
ABCD
A B
Slot 1
(1-4)
Input 1
Slot 2
(5-8)
Slot 3
No board
installed
Slot 4
No board
installed
Output 1Input 3 Input 4Input 2 Output 2
Input 5 Input 6 Input 7Input 8
Location A
Input
Location A
Output
Figure 2. Arrangement of Inputs and Outputs on the I/O boards
The board position designators correspond to the input and
output numbers served by that position (1 through 4, 5 through 8,
and so on).
The location designators, A through D, correspond to the DVI input or
output, grouped with inputs on the left and outputs on the right and
numbered from left to right.
The input numbers supported by the I/O board in locations
5 through 8 are as follows: A = 5, B = 6, C = 7, D = 8.
5DMS 1600 and DMS 3600 • Installation4 DMS 1600 and DMS 3600 • Introduction