Setup guide

2. On the next page that appears, select the Install the
software automatically radio button and click Next. Follow
the on-screen instructions. The wizard assigns the driver necessary
to access the switcher to the connected Configuration (USB) port
(this may take a few minutes).
3. Click Finish to exit the wizard.
NOTE: You may need to repeat these steps if you
subsequently connect the switcher to a different USB
port on the same computer.
Starting the Program
1. Click Start > Programs > Extron Electronics > Matrix
Switchers > MATRIX Switcher + Control Pgm.
The Comm Port Selection window appears.
Figure 9. Comm Port selection Window
2. Choose the comm (serial) port that is connected to the switcher,
USB, or IP [LAN].
NOTE: For a comm port, check the baud
rate displayed in the Comm Port
Selection window. If you need
to change the baud rate, click the
Baud button and double-click the
desired baud rate.
Click OK.
If you selected a serial port or the USB port in step 2, the Matrix
Switchers Control Program is ready for operation.
3. If you selected IP [LAN] in step 2, the IP Connection window
appears.
Figure 10. IP Connection Window
a. Examine the Matrix IP Address field, which displays the
last Matrix IP address entered.
If necessary, enter the correct IP address in the field.
NOTE: 192.168.254.254 is the factory-specified default
value for this field.
b. If the switcher is password-protected, enter the appropriate
administrator or user password in the Password field.
c. Click Connect. The Matrix Switchers Control Program is ready
for operation.
20 DMS 1600 and DMS 3600 • Remote Control 21DMS 1600 and DMS 3600 • Remote Control