User Manual
Table Of Contents
- DMS Configurable Digital Video Matrix Switchers
- Safety Instructions
- FCC Class
- Contents
- Introduction
- Installation
- Operation
- Programming Guide
- Matrix Software
- HTML Operation
- Installation
- Operation
- Programming Guide
- Matrix Software
- HTML Operation
- Maintenance and Modifications
- Ethernet Connection
- Warranty and Contact Info
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Maintenance and Modifications 105
3. Gently pull on the screws to loosen the fan from the backplane.
4. Slide the fan out of the chassis.
Installing a Fan Module
1. Orient the fan to be installed so that the printing on the back of the panel is right-side up.
2. Align the flanges on the fan with the top and bottom plastic chassis guides
(see figure 70, on the previous page).
3. Gently slide the fan into the enclosure until the fan meets resistance.
4. Gently seat the fan in the backplane.
5. Use a screwdriver to tighten the top and bottom screws to lock the fan in place.
6. Secure the row identification plate to the fan.