User Guide Manual

Command and Response table for basic SIS commands (continued)
Command ASCII command
(host to device)
Response
(device to host)
Additional
description
IP Setup Commands
Set unit name
EX1@
CN
}
Ipn•
X1@]
View unit name
E
CN
} X1@]
Set name to factory default
E
•CN
}
Ipn•
X4(]
Set time and date
EX1#
CT
}
Ipt•
X1#]
View time and date
E
CT
} X1#]
Set GMT offset
EX#
CZ
}
Ipz
X#]
View GMT offset
E
CZ
} X#]
Set Daylight Saving Time
EX3$
CX
}
Ipx
X3$]
Read Daylight Saving Time
E
CX
} X3$]
Set IP address
EX1$
CI
}
Ipi
X1$]
Read IP address
E
CI
} X1$]
Read hardware address
(MAC)
E
CH
} X1*]
Set subnet mask
EX1(
CS
}
Ips
X1(]
Read subnet mask
E
CS
} X1(]
Set gateway IP address
EX1$
CG
}
Ipg
X1$]
View gateway IP address
E
CG
} X1$]
Set DHCP on
E
1DH
}
Idh1
]
Set DHCP off
E
0DH
}
Idh0
]
NOTE: Changing DHCP from On to Off resets the IP address to the factory default (192.168.254.254)
View DHCP status
E
DH
} X%]
Set verbose mode
EX2@
CV
}
Vrb
X2@]
View verbose mode
E
CV
} X2@]
Get connection listing
E
CC
}
[number of connections]
]
NOTES:
X#
= Greenwich Mean Time offset GMT offset value (–12:00 to 14:00) representing hours and minutes
(HH:MM) local time is offset from GMT time
X%
= On/Off status 0=off/disable
1=on/enable
X1@
= Unit name Alpha-numeric up to 24 characters. No special characters except hyphen (-)
No upper/lower case distinction, no blanks or spaces, first character must be
alpha, last character cannot be hyphen.
X1#
= Local date/time Set: MM/DD/YY-HH:MM:SS
Read: day of week, date, month, year HH:MM:SS
(Example: Fri, 21 Jun 2002 10:54:00)
X1$
= IP Address default 192.168.254.254
X1*
= Hardware MAC address 00-05-A6-xx-xx-xx
X1(
= Subnet mask Default 255.255.0.0
X2@
= Verbose/Response mode 0=clear
1=verbose
2=tagged responses,
3=verbose + tagged responses
X3$
= Daylight Saving time 0=off/ignore ;
1= USA (begins first Sunday in April/ends last Sunday in October);
2= Europe (begins last Sunday in March/ends last Sunday in October);
3= Brazil (begins third Sunday in October/ends third Saturday in March).
X4(
= Alpha-numeric unit name combination of unit name and last three pairs of MAC address
DMP64 • SIS Programming and Control 99