User Guide Owner's manual

DFX 100 • Panels and Cabling 5
c
Optical output connector — Connect one end of one multimode fiber optic cable (not
provided) into this LC connector. The other end connects into the LC input connector
on the DFX 100 Rx. The cable can be up to 984 feet (300 m) in length.
CAUTION:
• Possible Damage to Eyesight. The DFX 100 Tx outputs continuous laser
(Class 1 rated), which may be harmful and dangerous to the eyes; use with
caution. Do not look into the rear panel fiber optic cable connector or into the
fiber optic cable itself. Plug the attached dust cap into the optical transceiver
when the fiber optic cable is unplugged.
• Possible radiation exposure. Use of controls or adjustments or
performance of procedures other than those specified herein may result in
hazardous radiation exposure.
DFX 100 Rx Rear Panel
POWER
12V
1.0 A MAX
INPUT
OUTPUT
DFX 100 Rx
POWER
12V
1.0 A MAX
INPUT
OUTPUT
DFX 100 Rx
a
c
b
3 feet (0.91 m) DVI cable
Figure 5. DFX 100 Rx Rear Panel
a
12 VDC power input — Connect the provided 12VDC power supply to the front panel
captive screw connectors. When power is provided to the unit but there is no DVI input,
the front panel lights amber.
See Figure 4, the attention points, and the notes on page 4 before connecting the
power supply.
b
DVI-D output connector — Connect a DVI-D display device to this male connector.
NOTE: Although the cable is terminated with a DVI-I connector, the receiver is
compatible only with a single link DVI-D signal.