Manual

Quick Start — DDS 100
Installation
Step 1
Install the four rubber feet on the bottom
of the DDS 100 digital display scaler
(1A), or mount the scaler in a rack (1B).
Step 2
Turn off power to the input and output
devices, and remove the power cords
from them.
Step 3
Attach the scaler to the input device, and
attach the output device to the scaler
(3A). It does not matter which set of
input connectors you use.
Input options (3B) are:
RGsB (connected to R, G, and B)
RGBS (connected to R, G, B, and H/HV)
RGBHV (connected to R, G, B, H/HV,
and V).
Output options are the same as the input
options plus VGA/XGA/SVGA/SXGA.
Connect only one input device and one
output device.
Step 4
Either attach a local monitor to the
unused set of input connectors and set
the 75Ω/Hi Z switch (4) to Hi Z, or
attach BNC 75Ω termination adapters to
the H/HV and V connectors of the
unused set of input connectors and set
the 75Ω/Hi Z switch to 75Ω.
Step 5
Set the sync selection switch (5) to the
desired output sync format. The format
must correspond to the output cables
connected. (H = RGBHV, HV = RGBS,
SOG = RGsB.)
Step 6
Plug the scaler, input device, and output
device into a grounded AC source, and
turn on the input and output devices.
Step 7
Use the LCD menu screens to configure
the scaler (see the next page).
RGsB
R
H/HV
G B
V
R
H/HV
G B
V
R
H/HV
G B
V
RGBS
RGBHV
VGA OUT
50/60 Hz 0.5A
100-240
INPUT/
LOOP OUT
RG BH/HV
V
H
HV
SOG
R
G
BH/HVV
VGA OUT
Input Output
oror
RS-232
REMOTE
50/60 Hz 0.5A
100-240
INPUT/
LOOP OUT
R G B H/HV
V
H
HV
SOG
R
G
BH/HVV
VGA OUT
RS-232
REMOTE
M
E
N
U
F
R
E
E
Z
E
/
R
E
S
E
T
N
E
X
T
DD
S 100
D
I
G
I
T
A
L
D
I
S
P
L
A
Y
S
C
A
L
E
R
C
E
N
T
E
R
I
N
G
/
P
A
N
Mounting Bracket
Each Side with
# 8 Screw (4 Plcs)
High Resolution
Workstation
Plasma
Display
LCD
Projector
LCD
Display
RS-232 Control
1A
3A
3B
45
1B
Rubber Feet
Bottom Side
(4 Plcs)
or
H
HV
SOG