User’s Manual CVEQ 100 and SVEQ 100 www.extron.com Extron Electronics, USA 1230 South Lewis Street Anaheim, CA 92805 800.633.9876 714.491.1500 FAX 714.491.1517 Extron Electronics, Europe Beeldschermweg 6C 3821 AH Amersfoort, The Netherlands +800.3987.6673 +31.33.453.4040 FAX +31.33.453.4050 Extron Electronics, Asia 135 Joo Seng Rd. #04-01 PM Industrial Bldg., Singapore 368363 +800.7339.8766 +65.6383.4400 FAX +65.6383.4664 © 2007 Extron Electronics. All rights reserved.
Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
安全须知 • 中文 警告 这个符号提示用户该设备用户手册中 有重要的操作和维护说明。 电源 • 该 设 备 只 能 使 用 产 品 上 标 明 的 电 源 。 设 备 必须使用有地线的供电系统供电。 第三条线 （地线）是安全设施，不能不用或跳过。 这个符号警告用户该设备机壳内有暴 拔掉电源 • 为安全地从设备拔掉电源，请拔掉所有设备后 或桌面电源的电源线，或任何接到市电系统的电源线。 露的危险电压，有触电危险。 电源线保护 • 妥善布线， 避免被踩踏，或重物挤压。 注意 阅读说明书 • 用 户 使 用 该 设 备 前 必 须 阅 读 并 理 解所有安全和使用说明。 保存说明书 • 用户应保存安全说明书以备将来使 用。 遵守警告 • 用户应遵守产品和用户指南上的所有安 全和操作说明。 避免追加 • 不要使用该产品厂商没有推荐的工具或 追加设备，以避免危险。 维护 • 所有维修必须由认证的维修人员进行。 设备内部没 有用户可以更换的零件。为避免出现触电危险不要自己 试图打开设备盖子维修该设备。 通风孔 • 有些设备机壳上有通风槽或孔，它们是用来防止 机内敏感元件过热。 不要用任何东西挡住通风孔。
Precautions, continued Quick Start Guide — CVEQ 100 & SVEQ 100 C Installation and service must be performed by authorized personnel only. To install and set up a CVEQ 100 and SVEQ 100, follow these steps: Step 1 Turn the input and output devices off and unplug their power cords. Step 2 Mount the CVEQ 100 or SVEQ 100 on a rack shelf, under a desktop, QuarterRackVersaToolsShelf through a desktop (CVEQ 100 only), or on the back of a rack (SVEQ 100 only).
Quick Start Guide — CVEQ & SVEQ, cont’d Step 5 Connect power cords and turn on the output devices (projector/ monitor, speakers), and input devices. Step 6 The picture should appear, and sound should be audible. If not, ensure that all devices are plugged in and receiving power. Check the cabling; make adjustments as needed. Chapter One • Introduction .............................................1-1 About this Manual .....................................................................
Table of Contents, cont’d CVEQ 100 and SVEQ 100 1 Chapter One Introduction About this Manual About the CVEQ 100 and SVEQ 100 TOC-ii CVEQ 100 & SVEQ 100 • Table of Contents
Introduction About this Manual Connection diagram example ® This manual provides information on the Extron VersaTools CVEQ 100 and SVEQ 100 video line drivers and discusses how to install and operate them. The following diagram is an example of how the various supported devices can be connected to the SVEQ 100.
Introduction, cont’d CVEQ 100 and SVEQ 100 2 Chapter Two Installation and Operation Mounting the CVEQ 100 and SVEQ 100 Rear Panel Features and Cabling Front Panel Features and Operation 1-4 CVEQ 100 & SVEQ 100 • Introduction
Installation and Operation Mounting the CVEQ 100 and SVEQ 100 The CVEQ 100 composite video line driver and the SVEQ 100 S-video line driver can be set on a table; mounted on a rack shelf; mounted under a desk or table; mounted through furniture (CVEQ 100 only); or mounted on the back of a rack (SVEQ 100 only). Tabletop use Rack mounting For rack mounting, do not install the rubber feet.
QuarterRackStandardShelf Installation and Operation, cont’d QuarterRackUnderdeskMounting Furniture mounting — under-desk 1U Universal Rack Shelf 1/2 Rack Width Front False Faceplate 1/4 Rack Width Front False Faceplate To mount the line driver under furniture, use the optional VersaTools® under-desk mounting kit for the SVEQ 100 (Extron MBU 123, part #70-212-01) or the optional under-desk kit for the CVEQ 100 (Extron MBU 125, part #70-077-01). Both front false faceplates use 2 screws.
Installation and Operation, cont’d Furniture mounting — through-desk (CVEQ 100 only) 2-6 Back of the rack mounting (SVEQ 100 only) To mount the CVEQ 100 through furniture, use the optional VersaTools® through-desk mounting kit (Extron MBD 129, part #70-077-02), as follows. The SVEQ 100 can be mounted to the rear of a rack using the BackofRackMountingEars Extron VersaTools MBB 100 back of the rack mounting kit (part #70-367-01).
Installation and Operation, cont’d Rear Panel Features and Cabling The following figures show the back panel configurations of the CVEQ 100 and SVEQ 100 line drivers. L L VIDEO 1 OUTPUT INPUT 12V 0.2A MAX 2a R VIDEO 4a 3 INPUT Outside 12V 0.
Installation and Operation, cont’d Tip (Signal) Ü á e To verify the polarity before connection, plug in the power supply with no load and check the output with a voltmeter. Sleeve (Gnd) Video output connector (CVEQ) — Connect a composite video output device to this BNC connector. S-video output connector (SVEQ) — Connect an S-video output device to these Y and C BNC connectors. Audio output connector — Cable a balanced/unbalanced audio output device to this 3.5 mm 5-pole captive screw connector.
Installation and Operation, cont’d Front Panel Features and Operation The following figures show the front panel configurations of the CVEQ 100 and SVEQ 100. GAIN EQ CVEQ 100 2a Equalization (EQ) potentiometer — Use an Extron Tweeker to rotate this pot to adjust equalization when the line driver is connected to long output cables. The adjustment range is 0 dB to +7 dB. The default is set to 0 dB (the dot position). See "Equalization (EQ) adjustment control" in this chapter.
Installation and Operation, cont’d CVEQ 100 and SVEQ 100 A Appendix A Specifications, Part Numbers, and Accessories Specifications Included Parts CVEQ100/SVEQ 100 Mounting Accessories Cables and Adapters 2-14 CVEQ 100 & SVEQ 100 • Installation and Operation
Specifications, Part Numbers, and Accessories Specifications Video Gain.................................................. Composite video and Y of S-video: -1 dB to +3 dB (x0.9 to x1.4), adjustable C of S-video: 0dB to +10 dB (x1 to x3), adjustable Equalization.................................... 0 dB to +7 dB (x1 to x2) at 5 MHz, adjustable Bandwidth (Y of S-video).............. 185 MHz (-3 dB) Output cable driving distance......
Specifications, Part Numbers, Accessories, cont’d Included Parts General External power supply.................. 100 VAC to 240 VAC, 50/60 Hz, external, autoswitchable; to 12 VDC, 1 A, regulated Power input requirements............ 12 VDC, 0.2 A Temperature/humidity................. Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing... Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing Rack mount.....................................
Specifications, Part Numbers, Accessories, cont’d A-6 CVEQ 100 & SVEQ 100 • Specifications, Part #s, Accessories CVEQ 100 & SVEQ 100 • Specifications, Part #s, Accessories A-7
Specifications, Part Numbers, Accessories, cont’d A-8 CVEQ 100 & SVEQ 100 • Specifications, Part #s, Accessories
