Operating instructions

4-5CrossPoint Matrix Switchers • Programmer’s Guide
Command/response table for SIS commands (Cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Global presets
Save current configuration as preset
Xb
, Spr
Xb
Command character is a comma.
Example: 9, Spr09 Save current ties as preset 9.
Recall a preset
Xb
. Rpr
Xb
Command character is a period.
Example:5. Rpr05 Recall preset 5, which becomes
the current configuration.
Start direct write of global presets
Esc
P
Xb
Write Preset
Xb
Ready Allows direct entry of presets.
{Tie commands} {Define ties for preset}
End direct write of global presets
Esc
p End Write Preset
Xb
Saves directly written presets.
Quick recall preset
Esc
. Rpr
Xb
Command character is a period.
1. This sequence of commands forces the switcher to perform a complete backplane switch
within 60 msecs of receipt of the Quick recall command.
2. The switcher ignores any invalid command or non-switching commands received between
the Start and End commands.
3. If there is no activity for 5 seconds, the switcher returns the timeout (E17) error.
4. The switcher disables front panel switching during this sequence of commands.
5. The switcher returns the invalid command (E10) error if it receives the End command
without the start command or the Quick recall command without a prior direct preset write.
6. The switcher must receive the Quick recall command within 100 msecs of the End
command.
Example:
Esc
P14 Write Preset 14 Ready Creates new preset 14 with:
1*3! A & V Input 1 tied to output 3
7*8% Video input 7 tied to output 8
1
10*4& RGB input 10 tied to output 4
1
12*4$ Audio input 12 tied to output 4
Esc
p End Write Preset 14 Stops entry, saves preset 14
Esc
. Rpr
Xb
Recalls the preset
Video mute commands
Video mute
X2
*1B Vmt
X2
*1 Mute input
X2
video (video off).
Video unmute
X2
*0B Vmt
X2
*0 Unmute input
X2
video (video on).
Read video mute
X2
*B
Xc
1= mute on, 0 = mute off.
Global RGB mute 1*B Vmt1
Global RGB unmute 0*B Vmt0
Audio mute commands
Audio mute
X2
*1Z Amt
X2
*1 Mute input
X2
video (audio off).
Audio unmute
X2
*0Z Amt
X2
*0 Unmute input
X2
video (audio on).
Read audio mute
X2
*Z
Xc
1= mute on, 0 = mute off.
Global audio mute 1*Z Amt1
Global audio unmute 0*Z Amt0
Executive mode
Lock front panel X Exe1 Enable executive mode.
Unlock front panel x Exe0 Disable executive mode.