User guide

Programming
Guide
The CrossPoint and MAV Plus matrix switchers can be remotely controlled via:
• The Matrix Switchers Control Program (see the Matrix Software, beginning on
page 110)
• Built-in HMTL pages (see HTML Operation, beginning on page 131)
• SIS commands (see below)
This section describes the operation of the CrossPoint and MAV Plus matrix switchers via
SIS commands, including:
• Serial Ports
• Ethernet (LAN) Port
• Host-to-Switcher Instructions
• Switcher-Initiated Messages
• Switcher Error Responses
• Using the Command and Response Tables
• Command and Response Table for SIS Commands
• SIS Command and Response Table for IP- and Remote Port-Specific
Commands
• Special Characters
CrossPoint and MAV Series Matrix Switchers • Programming Guide 89