Setup guide

DTP CrossPoint 84 IPCP • Contents v
Contents
Conventions Used in this Guide
Notifications
The following are used:
ATTENTION:
• Risk of property damage.
• Risque de dommages matériels.
NOTE: A note draws attention to important information.
Software Commands
Commands are written in the fonts shown here:
^AR Merge Scene,,Op1 scene 1,1 ^B 51 ^W^C
[01] R 0004 00300 00400 00800 00600 [02] 35 [17] [03]
E X! *X$* Y3%* Y3&* Y3^ CE}
NOTE: For commands and examples of computer or device
responses mentioned in this guide, the character “0” is used for
the number zero and “O” is the capital letter “o.”
Computer responses and directory paths that do not have variables are
written in the font shown here:
Reply from 208.132.180.48: bytes=32 times=2ms TTL=32
C:\Program Files\Extron
Variables are written in slanted form as shown here:
ping xxx.xxx.xxx.xxx —t
SOH R Data STX Command ETB ETX
Selectable items, such as menu names, menu options, buttons, tabs,
and eld names are written in the font shown here:
From the File menu, select New.
Click the OK button.
Specifications Availability
Product specications are available on the Extron website,
www.extron.com.
Introduction ...................................1
About this Guide .............................1
About the DTP CrossPoint Matrix
Switchers .......................................1
DTP Input and Output Signals ....3
Installation .....................................4
Rear Panel .......................................4
Video Inputs and Outputs ...........5
Audio Inputs and Outputs ...........7
Serial and IR Insertion
Connections ...............................8
Control Connections ...................8
Switcher Reset ............................8
Power ..........................................9
Additional Connector
Information .................................9
Front Panel ....................................14
Front Panel Operations ..................15
Creating a Tie ................................15
Recalling a Preset .........................16
Viewing Ties (and Muting Outputs) ...
16
Viewing and Adjusting Volume and
Mic Volume ..................................16
Setting the Front Panel Locks
(Executive Modes) .......................17
Selecting Lock Mode 2 or
Toggling Between
Mode 2 and Mode 0 ................. 17
Selecting Lock Mode 2 or
Toggling Between
Mode 2 and Mode 1 ................. 18
Remote Control ............................19
Selected SIS Commands ..............19
Establishing a Network (Ethernet)
Connection ...............................19
Number of Connections ............20
Establishing a USB Port
Connection ...............................20
Host-to-Switcher Instructions ...20
Common SIS Command Symbols
20
SIS Command and Response
Table for Matrix Switcher
Commands ............................... 21
Installing the programs ..............25
Starting the Product Conguration
Software ...................................26
Starting the DSP Congurator
Program ....................................28
Accessing the HTML Pages ..........30