Setup guide
Table Of Contents
- DTP CrossPoint 84 IPCP
- Safety Instructions
- FCC Class A Notice
- Contents
- Introduction
- Installation
- Front Panel Operations
- Remote Control
- Selected SIS Commands
- Establishing a Network (Ethernet) Connection
- Number of Connections
- Establishing a USB Port Connection
- Host-to-Switcher Instructions
- Common SIS Command Symbols
- SIS Command and Response Table for Matrix Switcher Commands
- Installing and Starting the Control Programs
- Starting the Product Configuration Software
- Starting the DSP Configurator Program
- Accessing the HTML Pages
- Selected SIS Commands
- Extron Warranty
- Contact Info
26 DTP CrossPoint 84 IPCP • Remote Control 27DTP CrossPoint 84 IPCP • Remote Control
4444444444
55
55555555
Figure 12. Download Center Dialog Box
4. Enter the requested personal information;
TIP: Click Remember Me to eliminate step 4 in future downloads.
5. Click Download to copy the software or rmware to your computer.
The download warns you about downloads and asks you to conrm
it.
6666666666
6. Cick Run to conrm that you want to run the installation.
7. Follow the on-screen instructions. The installation program creates
the necessary directories and folders and installs the programs.
Starting the Product Configuration Software
1. Click Start > Programs > Extron Electronics > Extron
Product Configuration Software > Extron Product
Configuration Software.
The Product Conguration Software opens to the Device Discovery
screen.
2222222222
1111111111
Figure 13. Device Discovery Screen
TIP: You can also launch the Product Configuration Software
from the DSP Configurator program, BUT PCS can be locked
out from within DSP.
2. Select (click) your DTP CrossPoint (
1
) and click Connect (
2
).
NOTE: The default IP address is 192.168.254.254.
The Product Conguration Software opens. Operate the program
as described in the DTP CrossPoint 84 User Guide, available at
www.extron.com, and the built-in Help le.
Figure 14. Product Configuration Software