Setup guide

DTP CrossPoint 84 IPCP • Remote Control 19 18 DTP CrossPoint 84 IPCP • Front Panel Operations
Selecting Lock Mode 2 or Toggling Between
Mode 2 and Mode 1
NOTES:
• If the switcher is in Lock mode 0 or mode 1, this procedure
selects mode 2. The Esc, Video, and Audio buttons ash twice.
• If the switcher is in Lock mode 2, this procedure selects mode 1.
The Video and Audio buttons ash twice.
Toggle the lock on and off by pressing and holding the Video button and
the Audio button simultaneously for approximately 2 seconds.
Lock mode 1
Lock mode 2
I/O
AUDIOVIDEO
I/O
AUDIOVIDEO
CONTROL I/O
AUDIOVIDEO
ENTER PRESET
VIEW
ESC
I/O
AUDIOVIDEO
Press and hold
for 2 seconds.
Press and hold
for 2 seconds.
Remote Control
This section describes using the remote control features of the
DTP CrossPoint matrix switchers to control the devices. Topics that are
covered include:
• Selected SIS Commands
• Installing and Starting the Control Programs
• Accessing the HTML Pages
Selected SIS Commands
You can use Simple Instruction Set (SIS) commands for operation and
conguration of the switchers (see SIS Command and Response
Table for Matrix Switcher Commands on page 21). You can run these
commands from a PC connected to an Ethernet port on the IPCP control
processor (item Q on page 8), serial port (item R on page 8), or USB
port (item A on page 14) on the switcher.
Establishing a Network (Ethernet) Connection
NOTE: The first time you connect to the switcher via the LAN port,
you may need to change the default settings (IP address, subnet
mask, and [optional] administrator name and password) of the
controller.
Establish a network connection as follows:
1. Open a TCP socket to port 23 using the IP address of the switcher.
NOTE: The factory default IP address is 192.168.254.254.
The switcher responds with a copyright message including the name,
rmware version, and part number of the product, and the current
date and time.
NOTES:
• If the switcher is not password-protected, the device is now
ready to accept SIS commands.
• If the switcher is password-protected, a password prompt
appears.
2. If necessary, enter the appropriate password.
If the password is accepted, the switcher responds with
Login User
or
Login Administrator.
If the password is not accepted, the
Password prompt reappears.