Setup guide

16 DTP CrossPoint 84 IPCP • Front Panel Operations 17DTP CrossPoint 84 IPCP • Front Panel Operations
Setting the Front Panel Locks (Executive Modes)
The matrix switcher has three levels of front panel security lock that limit
the operation of the switcher from the front panel. The three levels are:
• Lock mode 0 — The front panel is completely unlocked.
• Lock mode 1 — All functions are locked from the front panel (except
for setting Lock mode 2). Some functions can be viewed.
• Lock mode 2 — Basic functions are unlocked. Advanced functions
are locked and can be viewed only.
Basic functions consist of:
• Making ties
• Recalling presets
• Setting audio volume
• Changing Lock modes
Advanced functions consist of:
• Setting audio output mutes
• Setting front panel conguration
The switcher is shipped from the factory in Lock mode 2.
Selecting Lock Mode 2 or Toggling Between
Mode 2 and Mode 0
NOTES:
• If the switcher is in Lock mode 0 or mode 1, this procedure
selects mode 2. The Esc, Video, and Audio buttons ash twice.
• If the switcher is in Lock mode 2, this procedure selects mode 0
(unlocks the switcher). The Video and Audio buttons ash twice.
Toggle the lock on or off by pressing and holding the Enter, Video, and
Audio buttons simultaneously until the buttons ash (approximately
2 seconds).
Lock mode 2
Lock mode 0
CONTROL I/O
AUDIOVIDEO
I/O
AUDIOVIDEO
ENTERPRESET
VIEW
ESC
CONTROL I/O
AUDIOVIDEO
ENTER PRESET
VIEW
ESC
CONTROL I/O
AUDIOVIDEO
ENTERPRESET
VIEW
ESC
Press and hold for 2 seconds.
Press and hold for 2 seconds.
Recalling a Preset
A "preset" is a conguration that has been stored.
1. Press and release the Preset button.
PRESET PRESET
1 2 3 4 5 6 8
7
Recall a
preset
The Preset button lights.Press and release.
All input and output buttons with assigned presets light red.
When a preset is saved, the configuration data at
assigned preset locations is overwritten
.
INPUTS
2. Press and release the desired input or output button.
1
ENTER
The button blinks red to indicate that
this preset is selected to save or recall.
The Enter button blinks
red
to indicate the need to
activate the save or recall.
3. Press and release the Enter button.
Viewing Ties (and Muting Outputs)
1. Press the View button. Output buttons light for outputs that have no
ties established.
NOTE: If an output button blinks, the output indicated by that
button is muted. If only the Video or Audio button is lit, only the
video or HDMI audio is muted. To toggle mute on and off, press
and hold the output button for 2 seconds.
2. Press an input button. The buttons for all tied outputs light.
3. Press an output button. The buttons for the tied input and all tied
outputs light.
4. Press the View button again to exit View mode. All input and output
buttons return to an unlit state.
Viewing and Adjusting Volume and Mic Volume
Rotate the applicable knob clockwise to
VOLUME
MIC VOLUME
increase the program volume or mic volume.
Rotate the knob counterclockwise to
decrease volume.
The LED ladder indicates the approximate volume; the more LEDs are lit,
the higher the volume.