Setup guide
Table Of Contents
- DTP CrossPoint 84 IPCP
- Safety Instructions
- FCC Class A Notice
- Contents
- Introduction
- Installation
- Front Panel Operations
- Remote Control
- Selected SIS Commands
- Establishing a Network (Ethernet) Connection
- Number of Connections
- Establishing a USB Port Connection
- Host-to-Switcher Instructions
- Common SIS Command Symbols
- SIS Command and Response Table for Matrix Switcher Commands
- Installing and Starting the Control Programs
- Starting the Product Configuration Software
- Starting the DSP Configurator Program
- Accessing the HTML Pages
- Selected SIS Commands
- Extron Warranty
- Contact Info
DTP CrossPoint 84 IPCP • Front Panel Operations 15
14 DTP CrossPoint 84 IPCP • Installation
Front Panel Operations
This section describes simple DTP CrossPoint matrix switcher operation
from the front panel. Topics that are covered include:
• Creating a Tie
• Recalling a Preset
• Viewing Ties (and Muting Outputs)
• Viewing and Adjusting Volume and Mic Volume
• Setting the Front Panel Locks (Executive Modes)
Creating a Tie
NOTES:
• A "tie" is an input-to-output connection.
• A "set of ties" is an input tied to two or more outputs. (An output
can never be tied to more than one input.)
• A "conguration" is one or more ties, one or more sets of ties, or
a combination.
1. Press and release the Esc button to clear any input button, output
button, or control button indicators that may be lit.
2. Press and release the Video and Audio I/O buttons to select or
deselect video, audio, or both as desired.
I / O
VIDEO AUDIO
Green
when selected
Off when deselected
Red when selected
Off
when deselected
NOTE: Audio or video can be broken away (tied by itself) by
selecting only the Video button or only the Audio button.
3. Press and release the desired input button.
5
The button lights to indicate the selection.
4. Press and release the desired output buttons.
3 4
ENTER
8
Amber indicates video and audio tie.
Green
indicates video only tie.
Red
indicates audio only tie.
Green
indicates the need
to confirm the change.
5. Press and release the Enter button. All button indicators turn off.
Front Panel
Extron
1
2
3
4
1
2
34
5
6
7
8
CONFIG
INPUTS
OUTPUTS
AA
Figure 11. Front Panel Configuration Port
A
Configuration port — This mini USB B port serves a similar
communications function as the rear panel Remote port, but it is
easier to access than the rear port after the matrix switcher has been
installed and cabled.
NOTE: A front panel Configuration port connection and a
rear panel Remote port connection can both be active at the
same time. If commands are sent simultaneously to both, the
command that reaches the processor first is handled first.