User guide

CMP200 and CMP208
CPM200 and CPM208 • Installation
Installation, cont’d
2-6
3
Chapter Three
Maintenance and Modifications
Removing and Replacing the Enclosure
Replacing Cables or an MAAP
®
3. Reinstall the screws to secure the MAAP shelves in the
lower position within the enclosure.
Installing and cabling the MAAPs
Once the MAAP shelf is installed in the selected position, install
the cables and MAAPs in the CPM enclosure by connecting
the appropriate cable to the back side of each MAAP module,
or installing the cable in the split (cable slot) module, then
installing each MAAP module on the MAAP shelf.
DAV101
CM
VGA L
ine
Driv
er
Video I
npu
t
Powe
r
D
A
S
1
01
C
M
A
u
di
o
B
u
ffe
r
Figure 2-2 — Installing and cabling the MAAPs
Install the MAAPs as follows:
1. Route the cables up through the installed CPM unit from
the underside of the table or podium.
2. Connect the cables to the bottom of the MAAP(s) to be
installed.
- OR -
Install the appropriate sized grommet on the cable and
snap the grommet in place in half of a split (cable slot)
MAAP.
3. Thread the cable, with the MAAP attached, back into the
enclosure, then align the holes in the MAAP with the
MAAP shelf and install the hex screws to secure the MAAP
in place.
For split (cable slot) MAAPs, install the other half of the
MAAP to fully support the cable, making sure not to pinch
or bind the cable.
4. For strain relief, secure the cables to the holes in the bottom
edge of the CPM enclosure with tie-wraps.