User’s Manual TAPE DECK REW VCR CONTROL REW PLAY PLAY Tx FWD Tx FWD PAUSE PAUSE STOP IRCM-Tape STOP DVD CONTROL Tx MENU IRCM-VCR TITLE ENTER DVD CONTROL REW PLAY Tx NEXT PAUSE STOP REW PLAY NEXT IRCM-DVD STOP IRCM-DVD+ TONE CONTROL MAX/ MIN AUDIO CONTROL INPUT LEVEL PAUSE MIX LEVEL MUTE BASS MAX/ MIN TREBLE ACM-Tone ACM-Level CM-5BB AUDIO CONFERENCE Tx 1 2 3 ON/DIAL 4 5 6 HANG UP CM-20BB VOLUME SCREEN POSITION DOWN STOP UP 7 8 9 FLASH * 0 # UNMUTE
Precautions Safety Instructions • English This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk of electric shock. Caution Read Instructions • Read and understand all safety and operating instructions before using the equipment.
Table of Contents Chapter 1 • Introduction . ....................................................... 1-1 About this Manual .................................................................... 1-2 About the Control Modules ................................................... 1-2 Features ........................................................................................ 1-2 Chapter 2 • Installation and Operation ......................... 2-1 UL Requirements ..........................................
Table of Contents, cont'd Control Modules 1 Chapter One This page was deliberately left blank.
Introduction About this Manual This manual documents four types of control modules: Infrared Control Modules (IRCMs), Audio Control Modules (ACMs), Relay Control Modules (RCMs), and basic Control Modules (CMs).
IR IN SCP COM Installation and service must be performed by authorized personnel only. These products should be used with UL approved electrical boxes. C +12V OUT GROUND CONT MOD Installation and Operation MLC Not all wires to and from the Control Module are necessary (accessory dependent). A B C D E UL Requirements •. These units are not to be connected to a centralized DC power source or used beyond their rated voltage range. • These units must be installed in UL listed junction boxes.
Installation and Operation, cont’d ACM modules Front Panel Features and Operation d IRCM modules a Tx (transmit) LED — This LED lights whenever any control module button, with a control signal associated with it, is pressed. e All IRCM buttons must be set up before use. b c Basic functions buttons — These buttons replicate basic VCR, tape, or DVD player controls (e.g., rewind, play, stop, pause, etc.). DVD setup function buttons — These buttons replicate DVD player configuration controls (e.g.
Installation and Operation, cont’d RCM modules a b c N Screen Position Up/Down buttons — These buttons can be set up to toggle the screen to move up or down. Screen Position Stop button — Press this button to stop the up/down motion of the screen. Lighting On/Off button — This button acts like a light switch, toggling the room lights on or off when pressed. This button must be set up before it can control the lights.
Installation and Operation, cont’d CM modules a b Tx (transmit) LED — This LED lights whenever any control module button, with a control signal associated with it, is pressed. Dial Pad and Function buttons — These buttons replicate c audio conference system controls (e.g. dial pad, on/dial, volume controls, etc.). 1 Programmable buttons — You can program these buttons to control any IR-controllable device, or you can have RS-232 codes or relays assigned to each button.
Installation and Operation, cont’d A Control Modules Appendix A This page was deliberately left blank.
Specifications, Part Numbers, and Accessories Specifications General Power input requirements ........... 12 VDC, 0.08 A (CM-9BLB fully lit); 12 VDC, 0.026 A (CM-3BLB , fully lit), from an Extron MediaLink™ controller, System 5 IP, or external power supply All other models............................. 12 VDC, 0.020 A from an Extron MedialinkController (MLC), MediaLink Switcher (MLS) or System 5 IP Switcher. Temperature/humidity.................
Specs, Part Numbers, and Accessories cont'd FCC Class A Notice Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
