CIA112 INSTALLATION COMPUTER INTERFACE WITH TWO INPUTS AND MODULAR A / V FACEPLATE CIA112 OPERATION MANUAL
Installation and Safety Instructions For Models without a Power Switch: The socket outlet shall be installed near the equipment and shall be accessible. For all Models: No serviceable parts inside the unit. Refer service to a qualified technician. For Models with Internal or External Fuses: For continued protection against fire hazard, replace only with same type and rating of fuse.
1 Product Overview DESCRIPTION The CIA112 is a high-performance computer interface for analog video and stereo audio signals. The unit is compatible with a variety of analog video signals including VGA, SVGA, XGA, SXGA, UXGA, MAC, SUN and other high-resolution workstations.
2 • Sharpness Control - provides effective image enhancement for high-resolution video signals by increasing clarity and image detail, and may be used to compensate for signal loss due to long cable runs. • Modular A/V Connector Plates - The front panel accepts up to four A/V connector modules, available with a variety of popular connectors. • Hum Suppression Capability - removes visible effects caused by video ground loops that exist between the signal source and the interface.
3 Installation CAUTION: Installation of the CIA112 must only be carried out by qualified technicians. This section offers step-by-step instructions for installing the CIA112. An Application Diagram is provided on page 6, and Front and Rear Panel Connector and Control Diagrams are on page 7. Note: Read the instructions carefully before initiating the installation procedure. Before you begin, make sure that there is no power connected to the system, and that all the power buttons are off. 1.
4 6. Connect the Audio Cable to the appropriate pins on the CIA112 5-pin Phoenix connector. Make sure that the stereo audio output is connected appropriately for unbalanced or balanced as required by the installation (see diagram below). 5LJKW /HIW *URXQG /HIW 5LJKW *URXQG /HIW *URXQG 5LJKW 5LJKW %DODQFHG 5LJKW *URXQG 8QEDODQFHG Unbalanced Output - connect to the Left, Right and Ground connectors. Balanced Output - connect to Left +, Left-, Right+, Right- and Ground connectors.
5 11. Connect the Computer Sound Card Output (if applicable) to the CIA112 3.5mm female stereo audio input connector using an IN8200M-1 Series cable [15-pin HD with 3.5mm (M-M) mini DIN], or an IN9106 audio patch cable (3.5mm stereo mini male to 3.5mm stereo mini male). For computers with RCA connectors, use the IN9107 audio adapter cable [(1) 3.5mm stereo mini male to (2) RCA male]. 12. Connect the Local Computer Monitor (if applicable) to the local monitor output port of the CIA112.
Local Monitor PC CIA112 Operation Manual - V1.3 01/31/01 6 ©2001 - INLINE, Inc.
7 ©2001 - INLINE, Inc. CIA112 Operation Manual - V1.
8 HORIZONTAL POSITION CONTROL The location of the horizontal position control is shown in the Front Panel Connectors and Controls Diagram on the previous page. Press and release the rocker button to shift the image by one step to the left or right. Press and hold the button to shift the image continuously. Note: The horizontal position control has no effect on the local computer monitor.
9 DIPSWITCH SETTINGS Most installations will not require any changes to the dipswitch settings. The factory default and specialized dipswitch settings are indicated below.
10 Specifications CIA112 Installation Computer Interface with 2-Inputs & Modular A/V Faceplate Input Connector Type RGB Video Signals Input Impedance Sync Signals Horizontal Scan Rate Vertical Sync Range Stereo Audio Connector Stereo Audio Signals Output Local Monitor (Buffered) Main Output Output Signal Formats RGB Signals Bandwidth Rise and Fall Times Gain Main Audio Output Dimensions Faceplate Back Enclosure Product Weight Shipping Weight Power Power Supply Regulatory Compliance Safety & EMI (2) 15-pin
11 Required Accessories (Ordered Separately) Input and Local Monitor Adapter and Extension Cables: VGA: IN8000 Series 15-pin HD male to 15-pin HD female, various lengths from 3’ to 100’ For Other Computers: See the table on page 5 Optional Accessories Audio Input Cables: IN9106: 3.5mm stereo mini male to 3.5mm stereo mini male, 6’ long IN9107: (1) 3.
12 Problem: The power LED is on but there is no image on the display device. Solution: The vertical and horizontal sync wires may be reversed. Check the RGBHV cable connections at the interface output and at the display device input to make sure that the yellow wire is carrying Horizontal Sync signal information and the black wire is being used for Vertical Sync. Problem: The power switch is turned on, but the front panel power LED is dark.
13 A/V CONNECTOR MODULES Connector Module Black / White Description Type Size Video Modules IN9351B / IN9351W IN9352B / IN9352W IN9357B / IN9357W IN9363B / IN9363W IN9381B / IN9381W IN9382B / IN9382W IN9383B / IN9383W IN9390B / IN9390W IN9468B / IN9468W IN9475B / IN9475W IN9476DB / IN9476DW (2) BNC Female (1) 4-Pin Mini DIN Female (S-Video) (2) F-Connector Female (1) 4-Pin Mini DIN Female (S-Video) (1) BNC Female Barrel (1) BNC Female (1) F-Connector Female (1) RCA Female - White 4-Pin Mini DIN Female
14 Connector Module Black / White Description Type Size Control / Computer Modules CTL131DB / CTL131DW IN9356B / IN9356W IN9360B / IN9360W IN9361B / IN9361W IN9362B / IN9362W IN9364DB / IN9364DW IN9366DB / IN9366DW IN9374B / IN9374W IN9375B / IN9375W IN9378B / IN9378W IN9379B / IN9379W IN9389B / IN9389W IN9391DB / IN9391DW IN9394DB / IN9394DW IN9396DB / IN9396DW IN9397DB / IN9397DW IN9399B / IN9399W IN9452B / IN9452W IN9460B / IN9460W IN9464B / IN9464W IN9465B / IN9465W IN9466B / IN9466W IN9467B / IN94
15 ©2001 - INLINE, Inc. CIA112 Operation Manual - V1.
16 Warranty ♦ INLINE warrants the equipment it manufactures to be free from defects in materials and workmanship. ♦ If equipment fails because of such defects and INLINE is notified within two (2) years from the date of shipment, INLINE will, at its option, repair or replace the equipment at its plant, provided that the equipment has not been subjected to mechanical, electrical or other abuse or modifications.
