User`s manual

Cable Cubby
®
Products • Installation
Installation
Cable Cubby
®
Products • Installation
2-2
2-3
Installation Overview
Install and set up the Cable Cubby enclosures as follows:
1
If you plan to use a mounting template that has not
been prepared, prepare the template. See "Preparing the
Routing Template", on the next page.
2
Cut a hole in the surface where the enclosure will be
installed. See "Preparing the Table", later in this chapter.
3
Run all cables necessary to support the AC connector,
the cables stored in the cubby, and all planned AAP
connectors. Leave enough slack in the cables to connect or
route them before the cubby is installed in the table.
4
If applicable, install the power module. If your location
requires electrical conduit, install an Extron exible
conduit kit. Refer to the Flexible Conduit Kit Installation
Guide, Extron part #68-734-01.
5
Install all desired cables into the cable pass-through (split)
AAPs and install the AAPs into the Cable Cubby. See
"Installing the Cables and AAPs", later in this chapter.
6
If applicable, connect cables to the rear connectors on
the passive AAPs and install the AAPs in the cubby. See
"Installing the AAPs", later in this chapter.
7
Mount the Cable Cubby in the table. See "Mounting the
Cable Cubby", later in this chapter.
8
Peel the protective lm from the top surface.
9
Connect the Cable Cubby power cord.
Preparing the Routing Template
Extron offers metal templates for each Cable Cubby model; see
"Routing Template Part Numbers", in appendix A, "Reference
Information", for part numbers. Extron recommends using this
template as a guide to cut the hole in the table where the cubby
will be installed.
N
The metal routing template is reusable. Do not discard
this template when the installation is complete. Save it
for installing Cable Cubby models of the same size.
1
. Cut 1/2" x 4" strips of soft, nished lumber at least
long enough to span the distance between the desired
installation location on the mounting surface and the edges
of the mounting surface (gure 2-1).
These strips raise the routing template above the mounting
surface to provide room for the router’s collar, protect the
mounting surface, and extend the routing template’s reach
so that it can be clamped to the edge of the surface.
Mounting
Surface
Edge
Mounting
Surface
Edge
Wood Thickness
0.5" / 1.3 cm
Width of Mounting Surface
Routing Template
Wood Strip
Height
4" / 10.2 cm
Minimum
4 Screws
Wood
Strips
Figure 2-1 — Prepared CC 300 mounting template
2. Using four or more short wood screws, secure the
mounting template to the lumber strips.
C
Do not allow the wood screws to protrude through
the bottom of the wooden strips. Protruding screws
will mar the table when the template is used.