User`s manual

Cable Cubby
®
Products • Introduction
Introduction, cont’d
1-4
Cable Cubby
®
Products • Introduction
1-5
N
The elevation and arrangement of the power outlet
and AAPs in the Cable Cubby 200 are fixed and not
customizable.
The installed Cable Cubby fits nearly flush within a table or
podium top, storing the AAPs and cables out of the way and
out of sight. To access the AAPs and connectors, lift the lid
(figure 1-2). Half-moon cutouts in the lid allow you to run
cables in or out and then close the lid. For Cable Cubby 300s,
600s, and 800s, you can lower the lid into its recessed position.
Mounted
through a table
or podium
Extron
Cable Cubby 800
Hideaway Cable
Access Enclosure
Audio Cable,
Network Cable
15-pin HD Cable
Figure 1-2 — Typical Cable Cubby 800 application
The Cable Cubby 300 is available with either a round or a
rectangular top. The other Cable Cubby models all have
rectangular tops only. Preparing the table to install a
Cable Cubby 300C (round) requires simply drilling a hole in
the table with a 6-inch hole saw (figure 1-3). Preparing the
table to install a square cubby requires routing a square hole in
the table top. Sheet metal routing templates are available (see
"Routing Template Part Numbers", in appendix A, "Reference
Information" for part numbers).
1
2 3
Figure 1-3 — Cable Cubby 300C mounting
Features
 • EasyaccesstocablesandAAPs
 • Durablemechanicalmovement
 • CableCubby300,600,and800availableinavarietyof
surface finishes
 • Compactsize
 • FlexibleinstallationofExtronpassiveAAPs
 • GroundedACreceptacle(s)
 • UL/c-ULlisting
 • CSAcertication
 • Fitinarangeofsurfacethicknesses.Seethetablebelow:
Enclosure Minimum table
thickness
Maximum table
thickness
Cable Cubby 200 0.375" (3/8")
(9.53 mm)
Cable Cubby 300
0.571" (
≈19/32")
[14.5 mm)
3.23" (
≈3-1/4")
[82.0 mm]
Cable Cubby 600 0.75" (3/4")
[19.05 mm]
3.41" (
≈3-13/32")
[86.6 mm]
Cable Cubby 800 0.75" (3/4")
[19.05 mm]
3.41" (
≈3-13/32")
[86.6 mm]