User`s manual

Cable Cubby
®
Products • Packaging for Shipment
Packaging for Shipment, cont’d
Cable Cubby
®
Products • Packaging for Shipment
B-4
B-5
Figure B-3 — Removing center foam
6. CC 600 and 800 only — Remove and discard the inner side
foam sections of the cushion in the carton (gure B-4). If
you are returning a Cable Cubby 600 model, this is the
correct t. Proceed to step 8.
Figure B-4 — Removing inner side foams
7. CC 800 only — Remove and discard the outer side foam
sections of the cushion in the carton (gure B-5). This is
the correct fit for a Cable Cubby 800 model. Proceed to
step 8.
Figure B-5 — Removing outer side foams
8. If you will not install a replacement Cable Cubby in this
location, remove and retain one of the small foam sections
to the front or rear of the cubby opening in the cushion in
the carton (gure B-6).
Figure B-6 — Removing screw clamp area foam
9. CC 300, 600, and 800 only — Place the two screw clamps
from step 2 into the screw clamp opening in the foam
cushion in the carton.