User`s manual

Cable Cubby
®
Products • Packaging for Shipment
Packaging for Shipment
Cable Cubby
®
Products • Packaging for Shipment
B-2
B-3
The Cable Cubby has ultra-fine machined surfaces and moving
parts that make it vulnerable to damage caused by mishandling
during shipment if it is improperly packaged. If, for any
reason, you need to return a Cable Cubby to Extron, first contact
Extron to obtain a return kit. The return kit, which reduces the
chances of damage during shipment, includes a sturdy shipping
carton and foam that can be fitted to each Cable Cubby model
(figure B-1).
Figure B-1 — Cable Cubby return kit
Package a Cable Cubby for shipment as follows:
1. Contact the Extron S
3
Sales & Technical Support Hotline to
obtain a return kit. Extron will send the return kit to the
location you specify.
W
The flanged edges of the top of the surface enclosure
are sharp when the Cable Cubby is removed from
the table. Exercise caution when handling to
prevent personal injury.
C
The flanged edges of the top of the surface enclosure
are bevelled to an ultra-fine thickness of less than
0.04 (4/100)” (approximately 1 mm). These
edges are soft and can be easily nicked or bent.
Exercise caution when handling and mounting the
enclosure. Mishandling can damage the appearance
of the enclosure.
2
. Disconnect and retain all cables, remove and retain the
AAP shelf assembly(s) (CC 300, 600, 800) and remove
the Cable Cubby from the table or desk. See "Removing
and Replacing the Cable Cubby", steps 1 through 4, in
chapter 3, "Maintenance and Modifications".
N
For Cable Cubby 300, 600, and 800 models, retain the
screw clamps.
3. Install the plastic strips that protect the flanged edges of
the top of the surface enclosure (figure B-2).
Figure B-2 — Installing protective strips
N
For Cable Cubby 200 models, proceed to step 13.
For Cable Cubby 300, 600, and 800 models, continue to
step 4, below.
4
. Remove and retain the top foam pad from the carton.
5. CC 300, 600, and 800 only — Remove and discard the
center foam section of the cushion in the carton (figure
B-3). If you are returning a Cable Cubby 300 model, this
is the correct fit. Proceed to step 8.