User`s manual

Cable Cubby
®
Products • Maintenance and Modications
Maintenance and Modifications, cont’d
3-10
Cable Cubby
®
Products
4
From the underside of the Cable Cubby, gently push the
additional power module into the desired position at the
desired elevation. Secure the power module into position
with the included four Phillips head screws (gure 3-7).
2 Screws ea. side
Extron
Cable Cubby 600
Push module through
bottom of enclosure.
Secure in place with screws.
Figure 3-7 — Installing the power module
5
If desired, assemble and install replacement AAP shelf
assemblies. Remember that the cable pull function of the
Cable Cubby requires at least two AAPs. See "Installing
the Cables and AAPs" in chapter 2, "Installation".
6
If you removed the cubby from the table, reinstall the
surface mount enclosure. See "Removing and Replacing
the Cable Cubby", steps 8 through 11, earlier in this
chapter.
A
Appendix A
Reference Information
Specifications
Cable Cubby Part Numbers
Included Parts
Replacement/Modification Part Numbers
Routing Template Part Numbers
Top Plate Dimensions