User`s manual

Cable Cubby

Products • Installation

Installation, cont’d

2-12

Cable Cubby

Products • Installation

2-13

3. Carefully lower the Cable Cubby into the hole to test the

t. If necessary, remove the enclosure and use a le or rasp

to enlarge or smooth the edges of the opening (gure 2-7).

Mounting

Surface

Screw Clamp

Audio Cable

RJ-45 Cable

15-pin HD Cable

Cable Cubby 300C

Surface-Mountable

Enclosure for Cables, AAPs,

and AC Power Outlet

Figure 2-7 — Cable Cubby 300C, installation view

4. Cable Cubby 300, 600, and 800 — From the underside of

the table, reinstall the screw clamps on the enclosure at a

height at which the clamp will reach the underside of the

tabletop.

Do not overtighten the Phillips head screws on

the screw clamps. Overtightening can bend the

horizontal ﬂange of the screw clamp.

. Cable Cubby 300, 600, and 800 — Snugly tighten the

Phillips head screws on the screw clamps to secure the

enclosure to the surface.

6. Cable Cubby 300, 600, and 800 — Tighten the locking

thumbscrews on the screw clamps to lock the clamp in

position.

7. Cable Cubby 200 — Drill 1/8" (3 mm) pilot holes 1/2"

(12 mm) deep into the table in the mounting holes at each

of the four corners of the cubby.

. Cable Cubby 200 — Use the four included #6 wood screws

to secure the Cable Cubby 200 to the table (gure 2-8).

Figure 2-8 — Cable Cubby, installation view