User Manual
AVTrac Extensions • Before Getting Started2
Before Getting
Started
Tools and Equipment Required for Installation
Almost everything that you need to install your AVTrac kit has been included. You will need some basic tools and
materials depending on the facility and requirements.
NOTE: All structural steps and electrical installation should be performed by qualied personnel in
accordance with local and national building codes and electrical codes.
Extron recommends the following equipment (not provided) to ensure the AVTrac is properly installed:
Tools
Miter saw with blade for cutting metal
Hand saw for cutting drywall
Utility knives (box cutters)
Power drill
1/4 inches bit for drilling metal
Tin snips (metal shears)
Tools for terminating cables (if required)
Phillips head screw driver
Hex nut driver (1/4 inches and 5/16 inches)
Metal straightedge (for cutting carpet)
Other Equipment
Tape measure
Marker pen
Level
Fish tape (used for pulling cables through cavity walls)
Cable ties
Vacuum cleaner
Carpet glue
Safety goggles