User`s manual

Software Configuration and Control, cont’d
AVT 100 • Software Configuration and Control
AVT 100 • Software Configuration and Control
Advanced Instruction Set commands
The advanced instructions use hexadecimal commands that are more complex than the Simple Instruction Set. They are used by the Windows-based control program and special third party applications.
4-13
Command/response table for Advanced Instruction Set commands Command Hex command Response Additional information
(host to AVT 100) (AVT 100 to host)
Read/write entire memory (to back up or restore the system)
Read all memory contents 90 91 xxxx bytes of data + 1 byte checksum
Uploads all channels saved, active channel, presets, mode selection, and audio settings.
Write all memory contents 90 92 + xxxx bytes of data + 1 byte checksum
Dn1
Downloads all channels saved, the active channel, presets, mode selection, and audio settings.
4-12
Command/response table for special function SIS commands (continued) Command ASCII command Response
X!
values
(host to AVT 100) (AVT 100 to host) and additional descriptions
View Auto-Scan channels
View all channels 0*10# chn002 •
X!
List all channels.
chn003 •
X!
1 = Enable.
. 0 = Disable. . .
View specific channel
X1
*10#
X!
Show a specified channel.
For
X!
:
0 = Off. 1 = On.
X1
= Channel #.
CATV frequency selection (NTSC model only) Set frequency
X!
* 11# Cbl
X!
Select the set of frequencies used by your cable company: For
X!
:
1 = IRC. 2 = HRC. 3 = Standard (default). 4 = Japan standard.
View frequency setting 11# Cbl
X!