User`s manual
Software Configuration and Control, cont’d
AVT 100 • Software Configuration and Control
AVT 100 • Software Configuration and Control
4-11
Command/response table for special function SIS commands (continued)
Command ASCII command Response
X!
values
(host to AVT) (AVT to host) and additional descriptions
Audio configuration
Audio output mode
X!
* 7 # Mon
X!
0 = Stereo.
1 = Mono.
2 = Select left channel and output as mono.*
3 = Select right channel and output as mono.*
4 = Output same as input (R to R, L to L)*
5 = Output opposite of input (R in to L out,
L in to R out)*.
* This configuration is available only in PAL
versions, when Dual Channel is detected.
Audio configuration setup depends on the incoming audio signal. If stereo audio is detected on the current
channel, mode 0 (stereo) is the default. If a dual language channel (e.g., English on the left channel and Spanish
on the right) is detected on a selected TV/Cable channel, mode 2 (select left channel and output as mono) is the
default. The user can overwrite the default setting by setting up audio configuration via SIS command or the
Window’s-based control software, and the user’s setting is saved.
Example: 1 * 7 # Mon 1 Mono output.
View audio mode 7 # Mon
X!
IR remote control access on/off
IR receiver on/off
X!
* 9# Rmt
X!
0 = IR enabled (default).
1 = IR disabled.
Example: 1*9# Rmt l
Turn IR control off.
View IR receiver status 9# Rmt
X!
4-10
Command/response table for special function SIS commands (continued)
Command ASCII command Response
X!
values
(host to AVT) (AVT to host) and additional descriptions
Presets
Delete preset
X!
* 5 # Del
X!
1-99 presets each for cable and TV
Example: 25 * 5 # Del 025
Delete preset 25.
Change channel
Increment channel + 6 # TVC
X1
X1
values for NTSC:
002-069 (TV channel)
002-125 (cable channel)
X!
values for NTSC in Japan:
001-062 (antenna TV channel)
001-063 (CATV channel)
X1
values for PAL:
048-855 (antenna and CATV channel)
Decrement channel - 6 # TVC
X1
See
X1
values for decrementing the channel.
Set TV Channel
X1
* 6 # TVC
X1
See
X1
values for setting the channel.
Example: 056 * 6 # TVC 056
Set TV channel to 56.
View channel 6 # TVC
X1
View DIP switch setting
Antenna/cable selection 8 # Dip
X4
Shows whether the AVT is set to antenna
(TV) or CATV (cable) mode.
For
X4
:
0 = Antenna.
1 = Cable.
Example: 8 # Dip1
DIP switch has been set to cable.