User`s manual

Software Configuration and Control, cont’d
AVT 100 • Software Configuration and Control
AVT 100 • Software Configuration and Control
4-9
Command/response table for special function SIS commands Command ASCII command Response
X!
values
(host to AVT) (AVT to host) and additional descriptions
Preset and Tune modes Select mode
X!
* 1 # Mod
X!
0 = Preset.
1 = Tune.
Example: 1 * 1 # Mod 1
Enable Tune Mode.
View 1 # Mod
X!
Auto-Scan Activate Auto-Scan 2 # Scn Same function as holding down both channel
buttons on the front panel
Delete Auto-Scan channel
X!
* 3 # Del
X!
X!
values for NTSC:
002-069 (antenna TV channel) 002-125 (CATV channel)
X!
values for NTSC Japan:
001-062 (antenna TV channel) 001-063 (CATV channel)
X!
values for PAL:
048-855 (antenna and CATV channel) (1, 2, or 3 digits may be entered.)
Example: 011 * 3 # Del 011
Delete channel 11.
Add Auto-Scan Channel
X!
* 4 # Add
X!
X!
values for NTSC:
002-069 (TV channel) (001-062 Japan) 002-125 (CATV channel) (001-063 Japan)
X!
values for PAL:
048-855 (antenna and CATV channel)
Example: 011 * 4 # Add 011
Add channel 11.
4-8
Command/response table for special function SIS
commands
The syntax for initiating a special function is:
X!
* __ #
where __ is the function number and
X!
is the value.
To view a function’s setting, use:
__#
where __ is the function number.
In the following special functions command table, the values of
the
X!
variable are different for each command/function. These
values are given in the far right column.