User`s manual

Software Configuration and Control, cont’d
AVT 100 • Software Configuration and Control
AVT 100 • Software Configuration and Control
4-5
Command/response table for SIS commands
Command ASCII Response Additional
(host to AVT) (AVT to host)
information
Memory preset
Save preset (active channel)
X3
, Spr
X3
X3
= Presets 01-99.
Recall preset
X3
. Rpr
X3
chn
X1
Save preset (user-specified channel)
X1
*
X3
, pre
X3
chn
X1
X1
channel values:
NTSC antenna: 002-069
NTSC CATV: 002-125
PAL antenna (TV) and CATV:
048-855
View all presets
Esc
.
pre01chnxxx
through pre99chnxxx
Video mute
Mute on 1B/b Vmt
X2
Mutes video output.
For
X2
: 0 = off; 1 = on.
Mute off 0B/b Vmt
X2
Unmutes video output.
View video mute status B/b Vmt
X2
Shows muting status.
Audio mute
Mute on 1Z/z Amt
X2
Mutes audio output.
Mute off 0Z/z Amt
X2
Unmutes audio output.
View the audio mute status Z/z Amt
X2
Shows muting status.
4-4
Symbol definitions
= CR/LF (carriage return/line feed) (hex 0D 0A)
= Soft carriage return (no line feed)
•
= Space
Esc
= Escape key
X1
= Channel number
NTSC antenna: 002 – 069
NTSC cable: 002 – 125
NTSC Japan antenna: 001-062
NTSC Japan cable: 001-063
PAL antenna and cable: 48 – 855
X2
= Muting/Executive mode
0 = Off
1 = On
X3
= Presets 1 – 99 (The preset number cannot be more than two digits.)
X4
= Antenna or cable DIP switch setting
0 = Antenna (TV)
1 = CATV (cable)
X5
= PAL standard selection
0 = B/G (default)
1 = D/K
2 = I
X6
= Part number
X7
= Audio adjustment level: -63 through +12
X8
= Gain level: 0 – 12
X9
= Attenuation level: 0 – 63
If a command is not case-sensitive, this is indicated by showing the
command letter in uppercase, followed by a slash (/), then the same
letter in lowercase.
Examples: B/b, Z/z