User Manual

Software Configuration and Control, cont’d
AVT 100 • Software Configuration and Control
AVT 100 • Software Configuration and Control
4-7
Command/response table for SIS commands (continued) Command ASCII Response Additional information
(host to AVT 100) (AVT 100 to host)
Executive mode Disable 0X/x Exe0 Enables control via the front panel
by disabling executive mode.
Enable 1X/x Exe1
Locks out control from the front panel.
View Status X/x Exe
X2
Shows whether executive mode is on
or off.
Query firmware version Query firmware version Q/q x.xx Shows current firmware
version. x.xx is the format of the version number.
Request Part Number Request AVT 100 part number N/n
X6
X6
values:
NTSC = 60-647-01. PAL = 60-647-02.
Reset to default settings (Zap command) Zap settings/memories
Esc
zXXX ZapXXX The default settings are:
Tune mode All presets removed Auto-Scan channels cleared
4-6
Command/response table for SIS commands (continued) Command ASCII Response Additional
(host to AVT) (AVT to host) information
PAL standard selection (PAL version only) Select standard
X5
S/s Sys
X5
Select PAL standard.
X5
values are:
0 = B/G (default). 1 = D/K. 2 = I.
View status S/s Sys
X5
Show the current PAL standard.
Request information Request channel number I/i TVC
X1
X1
= channel number.
Audio gain and attenuation (NTSC model only) Set specific gain
X8
G Aud
X7
Set the gain to
X7
dB.
Range for gain (
X8
) is 0 to +12.
Set specific attenuation
X9
g Aud
X7
Set the attenuation to
X7
dB.
Range for attenuation (
X9
) is 0 to +63.
Increment gain or attenuation +G/g Aud
X7
Set audio level to
X7
dB by increasing
gain or attenuation. Default audio level is 0dB.
Decrement gain or attenuation – G/g Aud
X7
Set audio level to
X7
dB by decreasing
gain or attenuation.
View gain or attenuation G/g
X7
View current audio level in dB.