User Guide User guide

Command ASCII command
(host to processor)
Response
(processor to host)
Additional description
Advanced Configurations
Test pattern
Set test pattern
EX2)TEST} TestX2)]
Select test pattern
X2)
.
View test pattern
ETEST} X2)]
View which test pattern is used.
RGB delay time
Set value
EX3&VDLY} VdlyX3&]
Set RGB delay.
View setting
EVDLY} X3&]
View RGB delay setting.
Switch effect
Cut
E0SWEF
}
Swef0]
Sets the switch effect to cut.
Fade
E1SWEF} Swef1]
Sets the switch effect to fade
through to black.
View setting
ESWEF} 0] (or 1])
View effect setting.
Aspect Ratio mode
Enable Fill mode
E1Aspr} Aspr1]
Set aspect ratio to Fill.
Enable Follow mode
E2Aspr} Aspr2]
Set aspect ratio to Follow (default).
View aspect ratio setting
EAspr} X5%]
Show current aspect ratio
MTP Pre-peaking
Enable
E1OPEK} Opek1]
Enables pre-peaking on the MTP
output.
Disable
E0OPEK} Opek0]
Disables pre-peaking.
View setting
EOPEK} X1)]
View pre-peaking setting.
Front panel lockout (executive mode)
Enable Mode 1
1X
Exe1
]
Limited front panel adjustments.
Enable Mode 2
2X
Exe2
]
Lock out entire front panel.
Disable
0X
Exe0
]
Adjustments and selections can be
made from front panel.
View front panel lock status
X
X1$]
Show executive mode status.
NOTE: For full lock mode details see the “Setting the Front Panel Locks (Executive Modes)” section.
Picture in Picture
PIP on/off
PIP on
EX!PIP} PipX!]
Turn PIP on and display input
X!
.
PIP off
E0PIP} Pip0]
Turn PIP off.
View PIP status
EPIP} X!]
View PIP window selection.
NOTE: When PIP is enabled, all picture control commands apply to the image in the PIP window.
Swap PIP
Swap
%
Tke
]
Swap PIP/main window content.
NOTE: X! = Input selection 1 – 7
X1) = off/disable (0), on/enable (1)
X1$ = Disabled (0), or enabled mode 1 (1) or enabled mode 2 (2)
X2) = Test patterns: 0 = Off (default), 1 = Color bars, 2 = Crosshatch, 3 = 4x4 Crosshatch, 4 = Grayscale,
5 = Ramp, 6 = Alternating Pixels, 7 = White eld 8 = Crop, 9 = 1.33 Aspect ratio,
10 = 1.78 Aspect ratio, 11 = 1.85 Aspect ratio, 12 = 2.35 Aspect ratio, 13 = Safe area, 14 = Blue mode
X3& = RGB delay — 0 to 50, in 0.1 second increments (default is 05 = 0.5 seconds)
X5% = Aspect ratio, 1 = Follow, 2 = Fill
Annotator • SIS Communication and Control 50