User Guide User guide

Command ASCII command
(host to processor)
Response
(processor to host)
Additional description
Pixel phase
Specify a value
EX^PHAS} PhasX!*X^]
Set pixel phase to specied value for
active input.
Increment value
E+PHAS} PhasX!*X^]
Increase value.
Decrement value
E-PHAS} PhasX!*X^]
Decrease value.
View value
EPHAS} X^]
Show pixel phase.
Total pixels (RGB and YUVp/HDTV only)
Specify a value
EX&TPIX} TpixX!*X&]
Set total pixels to specied value for
active input.
Increment value
E+TPIX} TpixX!*X&]
Increase value.
Decrement value
E-TPIX} TpixX!*X&]
Decrease value.
View value
ETPIX} X&]
Show total pixels.
Active pixels
Specify a value
EX*APIX} ApixX!*X*]
Set active pixels to specied value for
active input.
Increment value
E+APIX} ApixX!*X*]
Increase value.
Decrement value
E-APIX} ApixX!*X*]
Decrease value.
View value
EAPIX} X*]
Show active pixels.
Active lines
Specify a value
EX(ALIN} AlinX!*X(]
Set active lines to specified value for
active input.
Increment value
E+ALIN} AlinX!*X(]
Increase value.
Decrement value
E-ALIN} AlinX!*X(]
Decrease value.
View value
EALIN} X(]
Show active lines.
3:2/2:2 Film mode detect
Enable film mode
EX!*1FILM} FilmX!*X1)]
Turn film mode detection on.
Disable lm mode
EX!*0FILM} FilmX!*X1)]
Turn film mode detection off.
View setting
EX!FILM} X1)]
View setting.
Command/Response Table for SIS Commands
NOTE: X! = Input selection; 1 – 7
X^
= Pixel phase; 0-31 (default = 16)
X&
= Total pixels; (±512 of the default value)
X*
= Active pixels; (±512 of the default value)
X(
= Active lines; (±512 of the default value)
X1)
= 0 (off/disable), 1 (on/enable)
Annotator • SIS Communication and Control 44