Owner's manual

GLI 350xi & ADA 2/GLI 350xi • Installation

Installation, cont’d

2-6

GLI 350xi & ADA 2/GLI 350xi

Under-furniture mounting

The GLI 350xi or ADA 2/GLI 350xi can be mounted under

furniture, such as a desk or table, using the optional MBU 125

mounting kit (Extron part #70-077-01), as follows.

1. If rubber feet were previously installed on the bottom of

the unit, remove them.

2. Attach the mounting brackets to the GLI with the provided

machine screws.

Under-furniture mounting of the GLI

3. Hold the unit with the brackets attached against the

underside of the table or other furniture. Mark the location

of the screw holes of the bracket on the mounting surface.

4. Drill four pilot holes, each 3/32" (2 mm) in diameter by

1/4" deep (6.3 mm) in the mounting surface at the marked

screw locations.

5. Insert #8 wood screws into the four pilot holes. Tighten

each screw into the mounting surface until just less than

1/4" (6.3 mm) of the screw head protrudes.

6. Align the mounting screws with the slots in the brackets

and place the unit against the surface, with the screws

through the bracket slots.

7. Slide the unit slightly forward or back, then tighten all four

screws to secure the unit in place.

Chapter Three

Operation

Front Panel Features and Operation

Rear Panel Features and Operation