User’s Guide AAP 100 MD MD Floor Box AAP Bracket Installation Kit 68-720-01 Rev.
Installation Introduction This guide covers installation of the Extron MD Floor Box AAP Bracket Kit in a Matsushita Denko (MD) floor box. It shows removal of the old bracket and installation of the new bracket/AAP unit. Installation C Installation and service must be performed by authorized personnel only. 1. Turn off and disconnect power from all equipment connected to the floor box. 2. Remove all cables connected to the portion of the floor box accessible 3. when the lid is open (if applicable). 3.
8. Attach and secure any single or double Extron AAP (for example, the double AAP shown below) to the MD AAP bracket with the 4-40 mounting nuts provided. 9. Connect cables, if applicable, to the back of the AAP to be installed. 10. Slide Bracket 10. Place the MD AAP bracket into the floor box (as shown above), routing any cables through the back of the box and slide it in the direction shown. 11. Attach with M4 Screws 11.
Installation, cont'd 12. Place the lid on the floor box and slide it away from the hinge to engage the tabs on the box. 13. Reinstall the two previously removed screws, securing the lid to the box. 13. Replace Screws 12. Slide 14. Reconnect power and cables, as necessary. Optional Extron Architectural Adapter Plates A variety of optional architectural adapter plates for pass‑through connections may be ordered for the MD floor box AAP bracket. Visit the Extron website at www.extron.
