Setup guide
40
XTP CrossPoint 1600 and 3200 • Remote Control
41
XTP CrossPoint 1600 and 3200 • Remote Control
Command SIS Command
(Host to Unit to Endpoint)
Response
(Endpoint to Unit to Host)
Additional Description
Input video format (available for endpoint input 1 only)
Set format
X!
*
X#
\ Ityp
X!
*
X#
*
X$]
Set input 1 on endpoint
X!
to
X#
video format. The
endpoint reports the detected video format,
X$
, in response.
Example:
1*0\
Ityp1*0*5
]
Set input 1 on endpoint 1 to auto. The endpoint reports RGB
video.
View format
X!
\
X#
*
X$]
Show set (
X#
) and detected (
X$
) video format for input 1 on
endpoint
X!
.
Image reset (available for endpoint input 1 only)
Execute an image reset
X!
A Aadj
X!]
Reset input signal timing to Extron default for endpoint
X!
.
SIS Command and Response Table for XTP T USW 103
NOTE: These commands allow you to control and monitor the universal switcher endpoint from the matrix switcher.
NOTE:
X!
= Input number 01 – 16 or 32
X#
= Set input video format 0 = Auto
1 = Video 4 = YUV interlace
2 = S-video 5 = RGB
3 = SCART 6 = YUV
X$
= Detected video format Identical to X#, above, except 0 = no signal.
Command SIS Command
(Host to Unit to Endpoint)
Response
(Endpoint to Unit to Host)
Additional Description
Horizontal shift (available for endpoint input 1 only)
Specify a horizontal position
E
I
X!
*
X^
HCTR
}
HctrI
X!
*
X^]
Set input
X!
horizontal position to
X^
.
Increment right
E
I
X!
+HCTR
}
HctrI
X!
*
X^]
Shift the
X!
input right.
Decrement left
E
I
X!
–HCTR
}
HctrI
X!
*
X^]
Shift the
X!
input left.
View the horizontal position
E
I
X!
HCTR
} X^]
Show the horizontal position.
Vertical shift (available for endpoint input 1 only)
Set a specic vertical
position
E
I
X!
*
X^
VCTR
}
VctrI
X!
*
X^]
Set input
X!
vertical position to
X^
.
Increment up
E
I
X!
+VCTR
}
VctrI
X!
*
X^]
Shift the
X!
input up.
Increment down
E
I
X!
–VCTR
}
VctrI
X!
*
X^]
Shift the
X!
input down.
View the vertical position
E
I
X!
VCTR
} X^]
Show the vertical position.
Analog input presets
NOTE: Analog input presets are a set of variables that can be saved. For the complete list, see the XTP CrossPoint Switchers User Guide.
Save an analog input preset
X!
*1*
X&
, Spr
X!
*1*
X&]
Command character is a comma.
Recall an analog input
preset
X!
*1*
X&
. Rpr
X!
*1*
X&]
Command character is a period.
NOTE:
X!
= Input number 01 – 16 or 32
X^
= Shift 0 through 65535
X&
= Analog input preset 1 through 8