User guide

Table Of Contents

Reset Button and LED

e Reset button (see figure 3 on page 8 and figure 4 on page 9) —

RESET

The recessed Reset button initiates four levels of matrix switcher reset. For four

different reset levels, press and hold the button while the switcher is running or

while you power up the switcher (see Reset Operations on page 18 for details).

• Events (mode 3) reset — Toggles events monitoring on and off.

• IP settings (mode 4) reset — Reset the IP functions of the switcher.

NOTE: The IP settings reset does not replace any user-installed firmware.

• Absolute (mode 5) reset — Restore the switcher to the default factory conditions.

• Hard reset — Restore the switcher to the default factory conditions and return the

switcher to the default firmware that shipped with the unit.

NOTES:

• Factory loaded ﬁrmware is active until it is replaced or the power is cycled.

• Hard reset does not clear the current conﬁguration.

Power Supply Modules and Indicator LEDs

f Primary and Redundant AC power connectors (see figure 3 and figure 4) —

Plug standard IEC power cords into these connectors to connect the switcher to

100 VAC to 240 VAC, 50 or 60 Hz power sources.

NOTE: For the most reliable power, connect the a power cord from the Redundant

power connector to either an uninterruptible power source or to a power source

that is completely independent from the primary power source.

g Primary and Redundant power supply indicator LEDs (see figure 3 and

figure 4) —

Green — Indicates that the associated power supply is operating within normal

tolerances.

Red — Indicates that the associated power supply is operating outside the normal

tolerances or has failed. See Removing and Installing a Power Supply Module on

page 78 to replace the power supply.

Cooling Fan assemblies

i Primary and Redundant cooling fans (see figure 3 and figure 4) — Cool the

equipment. If a fan has failed, replace it at your earliest opportunity. See Removing and

Installing a Fan Module on page 80 to replace the fans.

FOX Matrix 320x and FOX Matrix 14400 • Installation